Recent content by Nachobox

So cruiserparts emailed me back and said they have the pre-85 style condensers in stock. $214. As I already have the hoses I went ahead and ordered.

Same here. The Denso condenser for pre 05/85 FJ60s is discontinued. I also had an order for one through summit. I asked them to check last week and they said they reached out to Denso and its not gonna happen. Cruiserparts.net says they make their own pre 05/85 condensers but they haven't...

Haven't gotten all the crud off yet. It's very porous and brittle in some areas. Almost looks like quikrete. They look pretty short though.

I knew my 84 had an exhaust leak as there was a little bit of a tick under acceleration. She sat for about a month, and 5 minutes into my drive the tick went from slight to sounding like somebody doing full-auto mag dumps with a BAR... Turns out the prior owner decided he didn't need the full...

Engine fuse looks good. This started as an intermittent issue that has seemingly become permanent. I'm guessing something is loose or a bad connection somewhere. Yesterday it acted up and an hour later the solenoid clicked when i tapped the connections together and it started working again for...

Board does have a broken solder or two but with the trollhole it's a one wire setup that grounds through the carb, no ground circuit to complete on the board. I'll touch them up anyways but with a desmogged trollhole I don't think the board is doing much of anything anymore

Yeah the board might have a connection or two that's cracked but that would be the green ground wire that isn't hooked up anymore. I need to go over the electrical and find out why the yellow wire isn't getting 12v or find a new source.

Current line is showing nada on the voltmeter, ran a hot line from the battery terminal and it clicks... Sounds like I've got some wiring to do. Thanks guys

There's lots of empty/loose wires from the desmog and that one ties into the same loom the other wires go into. Earlier today I could hear a click when I would put the connection together and it all started working again. Now it's not clicking so something is loose somewhere. I guess if that...

Hey guys, I've been lurking here about a month and learning a lot but now I'm stumped. I've got an 84 fj60 that the previous owner put a trollhole carb on and desmogged. I feel like they cut some corners though and weren't very neat about it. Pretty sure I'm having issues with the ICS/fuel...