Recent content by MOORGUY

Also, for future reference for others, here are the spring numbers for the valve body (upper front, rear, and lower) along with the accumulators. Bolded ones are discontinued. 9050106043 9050107040 9050107042 9050107049 9050108062 9050108075 9050108146 9050109066 9050110098...

Hello all, i am trying to locate some springs for my A440F valve body. I have found all of them, with the exception of the 9050110094, 9050109056. Does anyone know where I might be able to find aftermarket replacements? My guess is that these were the most commonly worn, and thus the first...

Thanks NorCal97. "i like the fumes" hahaha Actually, the previous owner had used some mesh filler pieces and just bondo'd them in...which i hadn't discovered until I replaced the fender. The truck was flexed a lot offroad and never had an issue. This will be far, far stronger....not to...

body filler was added and sanded smooth: primed the surface for the time being (until all will be final sanded and reprimed) rear quarter panel:

coated with undercoating for extra protection: front side: i used a 36 grit flap wheel on a 4 1/2" angle grinder to remove the extra adhesive i made sure to sand the edges of the holes a bit- to create a nice taper for the body filler

Hello all, I recently filled the body panel holes in my 80 series, so I figured i'd share how I accomplished it. This may not be the cheapest way, but it will deliver great results without worrying about panels warping due to welding heat. The panel adhesive is the same stuff your door skins...

To my knowledge, the ECU does not do anything with this information. It just used to trip a the dummy overtemperature light. Does anyone know if the ECU actually uses the trans temp sensor on the A440F?

Yes, this replaces the factory sensor in the trans line. Also, the depth was ground down to .370" on the adapter, so that it matches the same depth as the original sensor. This means the reading is accurate, and doesn't interfere with fluid flow (any more than the OEM one).

Hello all, I did some research initially about temp sensor installs on the A440F....but couldn't find exactly what I was looking for. Here is the install I did on my 80 series: I pulled out the factory temp sensor (for the over-temp light) and found an adapter to work in this location. The...

I see this thread has gone way off topic, but I hope this helps future searches: Update: I ended up measuring mine out to see if it was in the acceptable range. It was at the high spots, however, there was a fair amount of grooving in the bushing. Seeing that I was having governor issues, I'm...

Hello all, I purchased a 92 land cruiser about a year ago and love it. I've been reading around the forums since my purchase, but I finally needed to make a post. I have recently had issues with the transmission not downshifting correctly when I come to a stop...and had intermittent "thuds"...