Recent content by mkw432

  1. mkw432

    I'm Screwed???!!! Sparkplug Threads Melted

    Welp, more bad news. The back tap barely engaged - took such little pressure to turn that hardly felt anything while turning it out. I'm not even sure it actually caught the threads - felt almost like spinning freely in air during each pass. I'd had a suspicion the new plug was falling through...
  2. mkw432

    I'm Screwed???!!! Sparkplug Threads Melted

    Hopefully I'll never need this tool again (or at least not for another 80k miles)! You're welcome to have it if you're ever down here around Wash Park. Though I should probably check the threads on the '05 4runner before I give it away :) I cleaned the #6 threads a bunch last night with TB...
  3. mkw432

    I'm Screwed???!!! Sparkplug Threads Melted

    Yep confirmed M14 with a 1.25mm pitch. Despite being literally called a back "tap" it's just a thread repair tool (chaser) that can't actually cut threads. The advantage is that it works from below so the crud is less likely to fall down into the cylinder. I watched my uncle use one on a Ford...
  4. mkw432

    I'm Screwed???!!! Sparkplug Threads Melted

    Pics aren't great but it does seem like there's a decent amount of thread left. I ordered an M14 back tap to try and chase them from underneath. Also vacuumed all that crud out of there using a spare piece of vacuum tubing poked through a rubber pipe cap and clamped to the end of my shop vac...
  5. mkw432

    Hello + Spark Plug Thread Repair

    Hello All! I have a mild build 2007 GX470 with RCI skids & sliders, Toytec lift (AHC/air bag delete), skinny 33" Wildpeak AT3Ws (255-80-17), a 180AH LifePo4 aux batter (with Renogy DC/DC charger), DIY drawer with fridge slide, DIY tailgate table (using a $12 metal pegboard panel) and Bison Gear...
  6. mkw432

    I'm Screwed???!!! Sparkplug Threads Melted

    @2001LC - I'm in Denver (Wash Park area) and was replacing the spark plugs on a 2UZ yesterday ('07 GX470). This one came out with the coil pack still stuck in the boot. Threads look stripped in that cylinder (thankfully #6 on the passenger side where there's plenty of room to work and not up...
Back
Top Bottom