Recent content by Mkent305

That’s makes sense I haven’t really had a good look at the 60 yet is there one on it or could I just by pass it and have it plumed straight to the booster from the back of the alternator

Thank you that helps a lot I do have a set of hj45 cross member L brackets that should work and yeah the 2h in the 60 did not have a edic someone has removed it and replaced it with a pull cable which make it a lot easier for me can use the existing bracket. Also will be pull the secondary fuel...

The old 2F has finally decided to give up, and I knew its time was probably getting close anyway. A few months ago I picked up an 82 HJ60 with the 2H and 4-speed specifically for this reason, so I’m looking at swapping the complete engine and gearbox into my FJ45. My main questions are...

Cheers for the reply mate I'll have to source one now thanks for the info 👍

Sorry, I should have said that it is a 1976 FJ45. And should the carb bolt straight onto the intake or should there be a block like this between them

I'm in Australia so fuel freezing not ging tobe a problem for me haha

So I recently bought a new ome carburetor to replace the holly because I wanted to run the factory air box just have a few questions about installing it do I need to have a heat insulator block or can I bolt straight onto the intake iv went out to my old man's to check the 2 wrecks we have and...

Sorry for the last reply I finally had some free time to work on the rig I put new spark plugs and a brand new battery. it ran and idle but a little ruff still but alot better then the other day I also got some brake cleaner and sprayed around the intake I found a leak the rpm never picked up...

Hey guys so I finally got started on my old boys fj45 it's been sat in the shed for about 5 years now with out it moving. Iv pull off the electric flue pump and replace it with a new mechanical pump then replace the old factory carb with a holley 330 from my old 2f But can't seem to get it...