Recent content by MetalcoreMoyer

I am also curious on why passing... I have read through that build thread several times over and while it will be a tight fit, I didn't see any show stoppers in there.

Thank you! Your 60 build was one of the few that inspired this nonsense. I'm aware it's going to be a tight fit, already lining up solutions to make sure it can be squeezed in there. Next steps are for me to pull the cab off the donor, get measurements, and begin cutting down the frame into a...

Sub'd, I might could need this for some V8 clearance.

It's not out of the question. I'm approaching for simplicity and success probability. Running and driving in 2WD with the factory 80 axles is the first step. If I start shredding the rear end and need to beef it up, phase 2 will be keeping disco parties away from the axles. The goal is an...

Well guys, my first post will be an insane one. I've been lurking in preparation for this project and it's finally kicked off. My 97' LX450 went down nearly a year ago, radiator exploded going down the highway and ended up sitting for a bit. Compression tested okay, but that 1FZ was tired...