Recent content by Marshpete

Thanks guys. I checked it cold. At the L mark. Checked at Operating temp it was at F. I think I’ll look around the Valve and see but I think everything is ok. Someone mention that adding half a quarter/ or filling reservoir a year isn’t an issue. I have heard a closed system shouldn’t lose...

So it’s clean on those two places. Is this a common issue the oil cooler cover plate?

I had to fill my coolant reservoir up today. I noticed a few months ago it was half full. Should I be concerned. 2013 with 75k on it.

Thanks for the info. I have since bought some Toyota coolant and will now monitor the levels. I will watch the level and see how rapidly it is being consumed.

Will do Thanks for the response

Thank you for your response. I checked after your post it doesn’t appear to have any fluid residue or cracks.

I agree and plan to bring it in if problem persist. I think I’d like to see how fast it’s using the fluid for a couple weeks. It is my wife vehicle so now I’ll be sure to monitor knowing there could be an issue. I created this thread to discuss other possibilities to look for regarding the...

Yes

My 13 200 series cruiser has low antifreeze in reservoir. It is just below the L marker. But shows some in the bottom of tank. Should I be concerned? I looked for antifreeze residue around the radiator cap and on bottom of the skid plate around the water pump. Truck has never shown any leaks...

I have a 2013 with around 48k miles. I went to camp in South Louisiana. The temp was below freezing for two days and average 20 or so, it also sat most of the weekend. When I cranked it mid morning a small puff of white smoke came out. Should I be concern or is this some what normal in low...

Does the 2016 Tundra not have a transcooler already on the Vehicle

I have company were I rent McPherson trench burners to contractors to burn stumps and wood debris on development projects. The burner weighs 8500-9000 lbs. I have pulled it with my tundra about 50 miles. It seemed to pull it just fine, however it squated the truck a fair amount. I pulled about...

Atwalz thanks you alway helpful. Thanks also to th other posters. What about the ride of 20" with 275/55 on the 200. Will it ride rough or tight.

I recently purchased a 2016 tundra limited. I own a 2013 200 I would like any and all info on swapping the wheels from the tundra to the cruiser and vice versa. First, any safety issues? Will they both fit on either vehicle? Will the PSI sensors from one vehicle work on the other? If not how...

Well I went to the shop and waited 2 hrs before they even thought about my truck. So I grab the wire and headed to the house. This morning the lights were off and everything seems to work fine. Thanks for the insight.