Recent content by manaraja

I assume and hope so! It appears I’ve paid all I need to but I will update here if otherwise.

Tariff charge was $19.88

Ordered from partsouq. Came out to around $120 shipped to Hawaii.

Had code p0330 on my 97’ pop up last year. Replaced knock sensor #2 with an oreilly part and the code went away, but came back a month later. I’m finally ready to replace it with an OEM sensor. Has anybody installed a partsouq or amayama knock sensor with no problems? They are the cheapest OEM I...

Just ordered it! Thank you for your help!

Much appreciated!

I think it just needs a rebuild. I’m glad to find that you were able to rebuild with domestic parts, do you mind giving me specifics on the t100 model/parts you used?

Been searching far and wide for a replacement clutch master cylinder but can’t find any, OEM, aftermarket, or even rebuild kits. I’ve been in contact with Japan 4x4 to no avail sadly. Does anybody know of another source that might help? Or have any extra lying around? I’d greatly appreciate it.

Thank you guys for the help! I ran it yesterday and all seemed back to normal. Saw a few mention in older threads that it takes a few start ups for things to get baseline, I assume that’s what happened in my case.

My 97’ didn’t start this morning, jump started it and everything was normal when I drove it for a few minutes. Had to jump it again after killing the engine and then idle was extremely low to the point of almost stalling. I noticed the negative ground was loose so I fixed that, now it starts...

I am located in Hawaii and I know shipping is difficult. Is there anyone in the LA area that has any in good condition? I can arrange shipping if in the area.

I’ll be sure to check those, thanks for the link!

Thank you for the help!

No crank, lights/radio all working as well as fuses in the box driver side foot space. Not sure where the starter relay is so haven’t checked that yet.

Thank you! Will give both a shot.