Recent content by Lugee

  1. L

    Door Lock Actuator Replacement

    Many use JB Weld Plastic Bonder. At least that is what I used.
  2. L

    UPDATED 09/12/2025!!! Huracan Fabrication Tailgate Storage Group Buy ENDS 09.26.25!!!

    I used an angle grinder. 4" wheel as to not cut the second skin. The supports I used tin snips, then cleaned it up with the angle grinder.
  3. L

    Prinsu Design 100 Series Full Roof Rack System

    I would recommend just using 3M tape like clear bra in that area. For me, my paint is already faded so the damage is already done.
  4. L

    UPDATED 09/12/2025!!! Huracan Fabrication Tailgate Storage Group Buy ENDS 09.26.25!!!

    I just got my shipment notification from UPS this morning followed by an email from Huracan Fabrications.. Should be here by tomorrow. Shipped from Accurate Metal Stamping in Fort Worth, TX. 5/2 update: installed it. Pretty simple install. - The template makes cutting easy. - The trunk...
  5. L

    Prinsu Design 100 Series Full Roof Rack System

    @Brentok Right now I am satisfied, but time will tell. I love the look and the clean lines. I just got back from a five day trip and it performed well. My shortlist before the Prinsu was Dissent and Gamiviti. It's been a while since I did the math, but the only reason I went with Prinsu was...
  6. L

    Prinsu Design 100 Series Full Roof Rack System

    @Brentok the side rails on the Prinsu are one single long piece, that hangs slightly to the outter edge of your roof. The weak spot for the prinsu would be bolts that mount the 80/20 to the side rails. I attached some photos showing how it bends off the side rails and mount. The other modular...
  7. L

    Prinsu Design 100 Series Full Roof Rack System

    My side rails were a bit crooked until I threw on the 80/20 (partially because it was floppy). I left the side rails a little loose while I bolted up the 80/20, then shifted it till I got it where I wanted and tightened the feet. The install was easy for one person to do, which I appreciate. As...
  8. L

    Prinsu Design 100 Series Full Roof Rack System

    I took the plunge and bought/installed the rack and load panels. I got free shipping, which helped keep costs down. Sealed it with butyl tape and urethane gasket maker. Install took me less than 2 hours (removal, installation). At first i was a unimpressed by how flimsy the side rails...
  9. L

    Dissent offroad aluminum front bumper!

    @gwatts I did a temporary install using scrap bar aluminum and drilled two holes onto it to thread the bolts through. I positioned the license plate on the lowest point of the top slot. The bar aluminum sits on the inside of the bumper, license plate on the outside., creating a sandwich that...
  10. L

    Dissent offroad aluminum front bumper!

    Same experience I had. No spacers, two of the bolts we're too long, I drilled my holes slightly forward to clear the front grill so I can close the gap. In hind sight, maybe drilled them closer and used one spacer. Edit: Other than the top plate bolt being too long, my front cap bolts we're...
  11. L

    Official 100 Series Black Friday Deals

    Does WKOR allow pick up? I just tried to order but there is no pick up option
Back
Top Bottom