Got some good info from cruiser outfitters that might help some. They said "many have used a 3/64" glass setting tape." Going to give something like this a try.
https://denverautofasteners.com/3-64-sealstrip-glass-setting-tape/?gQT=1
DId anyone pull their glass out of the frame like I did for paint? SOR has a pair but they are over 100 bucks for the two. Found these below also but don;t know if I want to wait a month while my door is sitting on my dining room table haha. I searched and saw people using inner tubes etc but...
Thank you!
My interior shop just said they’re going to try and make a suitable piece for now and if I get the original I can swap it out later. If it works will prob just leave it since you don’t see it
I have a 7/70 40 with the triple front bench. When I pulled apart the seats I failed to take a pic of the internal. Anyone know where these two plastic pieces go? Thanks
This is what i was looking for! Thank you. I have the 63-69 style that the PO stuck in there by drilling holes etc. I need the 1 bolt mounting hole style.