Recent content by KSDaddio

Seats and fabric in good condition. No tears, some surface dirt, foam in good shape.

Those look like ‘em. Did a stare and compare on EBay and mine do appear to be 4th gen. I am also in west valley “Surprise” area.

How can I tell? I got them for my 55 but went a different direction.

Have a set of font and rear older 4 runner seats in great condition.

Have some 55 rear seat frames with springs in good condition, for a good home.

I don’t think so. It’s factory but faulty, or worn out. 3F engines have these cam gear.

Baklite

I believe I found the problem, seems like we busted the c-clip that helps hold the timing gear in place. The gear worked loose, lost a number of teeth, which was allowing the cam to float back and forth causing the clunking sound. It also affected the timing (go figure).

$100

What part is the dog house and what you give me for it?

Hey all, looking for a quality machine shop in the Glendale/ Phoenix areas for engine work. Any recommends?

Last call for body clips. Front and rear

Not sure if I pushed Hamm too hard on the Williams trek or what, but he has developed a nasty knock akin to sloppy valve settings. I have verified correct lifter gap, cross checked timing, and am worried what it might be. Any input from the peanut gallery...

All has been going really well with the revitalization and took Hamm on a trek up to Williams for the Steam Engine Birthday.