Recent content by kruiserklan

  1. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    You’re welcome
  2. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    Yeah, it’s gone.
  3. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    I sold the seat and it may have been attached. I’ll look this afternoon to see if it’s still in the vehicle
  4. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    Is it attached to the seat is it attached to the seat or under the carpet? What’s it go to?
  5. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    Sorry for the delay. I have them and they are in good condition
  6. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    I’ll have to check on the condition. I won’t be able to get to it until next week
  7. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    Front seats are gone
  8. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    the lower tabs are a little rusty, but not bad considering it’s from Michigan. I’ll have to measure it up to figure out the shipping cost
  9. kruiserklan

    SOLD parting out '94 Land Cruiser. Brown cloth interior.

    I think I should have all of that. What is your zip code?
  10. kruiserklan

    Engine turns over, won't fire. please help! -resolved

    Yes the CEL was on and it is obd1. This morning I took the cap off again and scraped the two posts on the distributor with my knife, put it back together, pleaded with the Lord, and it fired right up. I don't exactly what happened, but I have a much better understanding of the ignition system...
  11. kruiserklan

    Engine turns over, won't fire. please help! -resolved

    I got my new fusible links today, but that didn't make a difference. I have the same voltage at the wire going into the coil as I do at the battery. The resistance on the coil is .9 ohms and 11.34 k ohms, and I don't seem to be getting spark still. I'm still waiting on my plugs, wires, cap, and...
  12. kruiserklan

    Engine turns over, won't fire. please help! -resolved

    The distributor cap and rotor actually looked to be in decent condition. They were unbranded, and the wires were import direct. It was the plastic retaining clip on the wire that was broke which caused the wire to fall off. I put everything back as it originally was and swapped out the coils...
Back
Top Bottom