Recent content by kng

we mig weld with .030 308l wire, the gas is a tri mix. argon, helium, co2

I own a muffler shop and cut out Toyota flanges daily, then weld in a small piece of 409ss with a welder that has 308l ss wire. 20 minutes if they are good welders. "typically" a small local shop would be more inclined to have a good fabricator than a large chain shop. One can have the flanges...

any other brake pads besides stop tech sport? tire rack says 60-90 days .How about akebono? hawk? i purchased the OEM rotors from the link elkeye posted(thanks elkeye)

no rear rotors and checkout doesn't work on the front rotors.

Looking for some good drilled rotors and new pads, I don't off road but want some rotors that wont warp in a year. also brake pads? tundra TRD pads? Are the ss brake hoses worth putting on for more responsive braking? or tundra calipers? Thanks

My rear hatch will lock but will not unlock on my 2015 LC ,any suggestions will be apricated. Thanks

ok any flushing or just drain and fill? 2 gallons?

Should i use toyota or amsoil antifreeze, i have 110k. should i just drain and fill or flush? Thanks

It was the O2 sensor on bank 1 sensor 2. The light is now of. thanks

ok, thanks where is the ECU Located? thanks

new extenders for the group 31, factory harness ends thoroughly cleaned . all connections are 100% tight (checked twice).

Just put a Dekka G31 in last month. all connection are tight 12.71 volts. alt charging indicates good. 13.86 unloaded 12.57 loaded. Thanks

Hello my 4 lo light came on and i pulled a p0607 code does anyone have any suggestions as to what is wrong? Thanks

Ohio just allowed us to remove our front license plate, is there a lower grill available in black that does not have the mounting bracket built in? Thanks Kirk

Thanks for the info guys! i dont need them til after winter, goin start looking around now though.