Not having much luck looking online does anybody know a place preferably around NZ and Aus where I can find a 24v mechanical external voltage regulator.
Yeah I’ve looked at this before. I get what it’s saying but I’m not exactly sure what I’m looking for when doing it? I get the fuel will be pushed out of the injector port, but am I looking for it to be at the surface each time the crank does 1 revolution back to 14 deg BTDC
Ahh no I don’t believe so. I installed the fuel pump but I made sure to triple check the marks etc as I installed it.
Here’s a quick timeline.
Start if the thread: it had a rough starting and high EGTs
Since the start of the post first thing I believe was I loosened the fuel pump and angled...
Yep Injectors and fuel pump were both refurbished before first start of the engine. Iv had a fiddle with the pump. I’ll keep tweeking it to see how I got. At this stage after winding in the fuel screw for less fuel when it starts after about a second or 2 it goes into a slightly rough idle but...
Ill
give this a look over on the weekend cheers for that. I’ll get back to you
Also my alternator has one thick red wire which is to battery then a plug that has 3 wires in the top also as seen in the photo
Bit of an cross over here. I have a Series 3 Land Rover fitted with a Toyota 3B. Engine is a fresh rebuild, and the alternator has been recently bench tested etc and in perfect working order (kind of) the external regulator hasn’t been tested/used properly since it was last tested properly over...
Just thought I give a reply.
After reading this I fiddled with the fuel pump and it now drives and starts better. EGTs are better now and the engine stays at a good temp at idle and open rd
Nah I’m not saying I have to floor it to get to 70. I’m just saying if I give it full jandal at 50km/h by the time I’m at 70 my EGTs are at 600 and climbing. So I choose to let off the throttle.
There’s definitely a bit of me wanting to baby the engine while it’s still been run in, cause I...
That’s probably part of it. It is only about 150km into its 600km run in stage.
The issue is I could plant my foot and would get upto and past 700 degrees and I’d only be at 70km/h
Haha I appreciate that. Definitely a major upgrade from the factory 2.25 diesel that was in it
Yeah I wouldn’t say there’s any lack of power. It’s just me being more mindful of my EGTs now that I have a gauge for it and the motor only has about 150km on it since the rebuild I might try tweak...
Just had a brief look at your guide. As far as exhaust goes it’s pretty free flowing. It ends past the driver door and before the rear wheel, and has straight through hotdog muffler.
The intake isn’t complete yet as I still plan on making a snorkel with either a ram air intake or a mushroom top...
Tyre size is 285/75/r16 so just under 33”
The old 3b that was in it before I put in my reconditioned one never had an issues with the tyre size speed/acceleration wise. Granted I also never had an EGT gauge