Recent content by Kire5

I also replaced my module but it didn’t fix the problem!

@mrboatman I am also having ignition problems and ran this test to see if it my new igniter was bad. I was able to see the light flicker when the engine was cranked to I think it’s fine. Two things I saw though: 1) when I attached my multimeter instead of the test light it only went up to...

Thank you for all the tips! I fortunately was able to drive my existing shackles out with a hammer fairly easily (well other than the shackle I had to sawzall out to avoid dropping the exhaust system). But I struggled using the bottle jack to lower the leaf spring to align with the new shackle...

I might have found one - does this look right? https://www.mouser.com/ProductDetail/ROHM-Semiconductor/BA7807CP-E2?qs=Bakm8ERcljp0D%252BecpRGTrg%3D%3D

Thank you!! Where can I find one of these linear voltage regulators? I have googled a bunch and am striking out! I found one that are 5V out but not 7V

It took out my instrument cluster to troubleshoot the fuel and temp gauges not working and found this damage to the circuit board. Is this repairable? I also found damage to the fuel gauge - not sure which came first!

So I ended up using the hole in pic #2 for a fire extinguisher….

Ha ha - it’s POEM (previous owner equipment manufacturer)

Hello everyone - I was wondering if you all could help me figure out what these bolts/holes are for!

Do you still have the bottom set? If so, how much?

Hello all! This may be a long shot, but I am missing the offset bracket/plate/link that connects the motor to this wiper linkage on my 76 FJ40 - see red arrow below for part I need. Does anyone have an extra The would be willing to sell?

Thank you!

Can anyone show me what gets mounted here at the top corners of rear door opening? Thank you!

Hello everyone, noobie here! I am attempting to fix up some of the wiring on my car and want to make sure I am doing it correctly. Please see the pics for labels to my 4 questions. A) I believe the BY wire from the + terminal of the ignition coil is supposed to connect to this terminal on...

I was wondering if you remembered w the specialist is in Wilton, CT? Thx