Recent content by KeyWest

  1. K

    Additional Oil Cooler Pressure Sensor

    I have a 2F engine with oil cooler. Want to add an aftermarket oil pressure gauge, but still want to keep the stock gauge working. My question is; Can I replace the front oil cooler bolt with one like the rear (threaded for sending unit) and have a sending unit on each oil cooler bolt? This...
  2. K

    FJ40 2F Engine Alignment

    Never thought about the frame being bent. My guess that a 40 year old vehicle has had a few bumps along the way. Gonna check that this weekend. Thanks to everybody for the help.
  3. K

    FJ40 2F Engine Alignment

    - Didn't take a baseline measurement, never even thought of doing that. Thanks for the future recommendation. - All the bolts are dropping in, not a problem with mounting. - I am measuring from two reference points at the 3 and 9 position on the harmonic balancer. One reference is forward...
  4. K

    FJ40 2F Engine Alignment

    Engine and trans were from the cruiser. New motor mounts on engine and tranny.
  5. K

    FJ40 2F Engine Alignment

    The '81 is like the Fj60, there is a crossmember under the transmissions. Transmission mount goes in without a problem.
  6. K

    FJ40 2F Engine Alignment

    Thanks, should have explained better. Pulled both the transmission and engine, rebuilt, dropped them back in as one unit. Body is off the chassis. Walt
  7. K

    FJ40 2F Engine Alignment

    Dropped my engine back in the chassis this weekend and can not seem to get it aligned straight - the passenger side is a little forward of the drives side. Measuring off the harmonic balancer, the passenger side is about 1/4" forward of the drivers side. Questions: - How straight does it...
  8. K

    HEI Distributor Recurve?

    In the process of desmogging my F2 engine. Was thinking about going to a DUI HEI dizzy. I know that my stock dizzy needs to be recurved, but what about using DUI HEI dizzy. Does that need to be recurved also? Walt
  9. K

    Captive Lockwashers

    Not a bad idea, I was also considering using a loctite.
  10. K

    Captive Lockwashers

    What about the bolts with lock washers? Its the lock washers that are the main issue. The lock washers are flat and not reusable. Also, there are several good sources for JIS washers and lock washers on line. I have had good luck with us.misumi-ec.com
  11. K

    Captive Lockwashers

    In the process of pulling my bell housing and transmission, noticed most of the bolts have a captive lock washer (some also have a captive washer). I was planning on just cutting the old lock washer off and using a new one. This there any problem doing this? Cant see that there would be...
  12. K

    Texas F2 Engine Rebuilder

    Have an '81 Fj40 F2 engine that needs to be rebuilt. Looking for recommendations for rebuilders in Houston and Texas. Thanks in advance!
Back
Top Bottom