Recent content by KenaiFJ40

  1. K

    Carburetor help needed

    Thanks for the reply. I just got the new gasket in. I looked at another intake I had and the thickness of it matched my header much better. It worked out pretty good. Much quieter now and running nice. Thanks for all of the help. On to the 79 axles...
  2. K

    Carburetor help needed

    Thank you for all of the suggestions. I was able to get it running so much better. The timing was quite off. When we got that adjusted, it ran much better, but still had a little stumble. We checked the gap on the points and it was too tight. We adjusted that gap and adjusted the timing again...
  3. K

    Carburetor help needed

    Yes that wire is connected.
  4. K

    Carburetor help needed

    Yes I have a hose from my intake to the other side of the engine like that.
  5. K

    Carburetor help needed

    What is the pvc hose? I does have a header and I am familiar with the stock exhaust and how it heats the intake. I will take more pictures of the hoses and where they go tonight and check the dizzy and points.
  6. K

    Carburetor help needed

    Not sure if the intake is original or put on when the carb was changed. This is how I have it set up now.
  7. K

    Carburetor help needed

    The only other parts I have from the old carb that are not in the pictures are some of the linkage parts I had to fit to the new carb to hook up my throttle cable. I was thinking that the 75 was supposed to have linkage. I think they must have swapped the linkage out with the cable when they put...
  8. K

    Carburetor help needed

    That is one thing I don’t know much about. Unfortunately I don’t know much about a Toyota carburetor either, but I do know my way around a Mikuni snowmobile carb quite well and trying to transfer the knowledge to this carb project. I have a friend with a timing light coming over in the morning...
  9. K

    Carburetor help needed

    So I need a lot of help. I have a 1975 fj40. It does have a 2f engine. It hasn’t been running for about 4 years and before that I had it running for about two years, but not very well. Previous to me owning it, I believe that it was sitting for a long time. When I parked it several years ago...
  10. K

    Need help with 1975 FJ40 tail lights

    I almost have it. Talked to a guy that does a lot of trailer lights. He thought I had a resistance issue and he told me to try an electronic flasher. I got one, put it in and it all worked great. Even the hazards worked. Then after a few more tries the hazards quit working, but everything else...
  11. K

    Need help with 1975 FJ40 tail lights

    The FJ40 came with taillights that had an amber blinker run off of a separate wire. That is my understanding anyway - my factory lights are long gone. Basic trailer taillights use a dual filament bulb and the brakes and blinker are both on one wire. It is my understanding that this is why I need...
  12. K

    Need help with 1975 FJ40 tail lights

    The tail light assemblies are new. I am pretty sure it has dual filament bulbs with the tail lights on one and the brake/blinker on the other.
  13. K

    Need help with 1975 FJ40 tail lights

    I just recently purchased a 1975 FJ40. Pretty well stock with a considerable amount of rust. I am trying to get some cheap 2 wire tail lights (non LED) working so that I can drive it around town. I purchased a tail light converter that has car side wires for Left turn, Right turn, Stop, Tail...
Back
Top Bottom