Recent content by JPALMS

Hey guys. I've been tinkering around with my cruiser, mainly wiring for the most part (not so EZ wire). I'm going to swap out my stock steering column for a GM column. One reason is for compatibility with my harness and the other is for comfort in the driver seat that the PO put in. I'm not...

Thanks, Rudi. How about the connection on the bottom right in this picture? Is that related to the speedo as well? What is it's function? Thanks for any help.

What is the connection in the center for that has the black housing around it? I have this gauge but can't find the wiring diagram for it and don't know what that connection is for. Thanks for any help!

Thanks for the help! I will let ya know how it goes when I get a chance to get out and work on it. Appreciate the insight.

Hey guys, looking for any insight on wiring an ez wire harness to my existing steering column. I have listed what I have below currently. I'm not much of a wiring guru but have made it to this point and I'm eager to get the rig fired up and not ON FIRE. EZ wire -ignition switch start...

Question for ya? My harness in regards to my headlight switch (my guess) -???? (Top left) -park lights (bottom left) -headlight power (top right) -dimmer (bottom right) The headlight power and dimmer are both direct wires into my fuse box. There is also a dimmer switch that Looks to go into...

I figured there would be. A few of those secrets! Thanks for the insight.

Another question for you due to my wiring experience being limited to none. My harness has a LEFT TAIL PARK wire, and a LEFT FRONT PARK wire. How do I account for both off of the one connector (being the bottom left on the picture)?

Here is an addition to the thread. If I remember this was one of the missing years that was added later into the thread. My housings were shot but here is a look at the cluster.

Thanks for the speedy reply. Much appreciated. I've seen others with 5 prongs with one going to gauge lights. That's where I was tying it into this thread to see if I was mistaken on the contacts and whether or not one went to the gauge lights.

Hey everyone I'm new to the forum and have been very impressed with the wealth of knowledge here. I recently picked up a 73' FJ40. I had looked for awhile and finally found one. I've already dove in and have been putting in a new wire harness. Rig has a 305 small block in it. Can't wait to get...

Sorry for the typo above. My rig is a '73 FJ40.

Thanks Hobbes, still learning a lot about these. Appreciate the info. I will correct it ASAP.