Recent content by joshik

  1. J

    Leaky '03 V8 4runner

    that would be awesome if that is the issue. I am replacing the valve covers. I'lll do the dipstick when I get back from my trip. Thx for the tip!
  2. J

    Leaky '03 V8 4runner

    Hey! I recently hit 320k on my 03 V8 4runner. Been running strong but of course there are some leaks. I knew of my valve cover leak which I plan to take care of soon and of course the infamous tcase actuator. But lately, it seems like a lot more is leaking so I took it into my local shop...
  3. J

    For Sale FS-NIB Bilstein 6112 Coilovers for 4th Gen - $600 North San Diego, CA

    I have a new never mounted Bilstein 6112 Coilover set for 4th Gen 4runner. These were bought in 2021. The Kit number is: 47-260153 The strut part number is: 24-260169 The spring part number is: E4-FD1-Z005B50 - 600LB spring rate. You reuse your OEM top hat and rubber isolator. Comes with...
  4. J

    Renogy 50amp DCDC w/ MPPT - Chassis Ground?

    thanks for the vid! yeh so much varying info out there. 10% voltage drop ok. No more than 3%. etc etc. As for the wire, I got some 105C rated pure copper 370strand 4awg wire so following what the video says, i should be in the clear.
  5. J

    Renogy 50amp DCDC w/ MPPT - Chassis Ground?

    cool thanks for the links! the links were saying for DCDC you should not exceed 3% voltage drop. But I guess I could just lower the max charging AMPs to 30 which is plenty as well. That should keep things well within spec.
  6. J

    Renogy 50amp DCDC w/ MPPT - Chassis Ground?

    Oh. What about risk of the wire heating up and causing a fire?
  7. J

    Renogy 50amp DCDC w/ MPPT - Chassis Ground?

    Hi. I am installing a Renogy 50A DCDC w/MPPT charge controller to charge my house battery located in the cargo area of my 4runner. The diagram shows that the both the starter battery (charge source), house battery and solar panel all connect to the controller's common ground. Could I...
  8. J

    anyone have OEM rear bump stops?

    awesome yes i will take them. i will PM u
  9. J

    anyone have OEM rear bump stops?

    looking for OEM rear bump stops. Maybe someone has some take-offs after installing aftermarket ones? Willing to pay. LMK! :D
  10. J

    Viair 400P on-board air install

    Resurrecting an old thread here. I have the 400P w/ the pressure switch and was planning on installing it under the hood of the 4R. That compressor gets insanely hot during use and it's already hot under the hood. I'm not worried a whole lot about the longevity of the compressor but do you...
Back
Top Bottom