Recent content by jlasey

  1. J

    1975 FJ40 Tie Rod Ends

    Just replaced the tie rods ends. First, the part numbers below match with the dorman parts I found on rock auto. Total at the time of purchase was $64. I did a terrible job measuring the tie rod lengths before removal. Also, had to clean up the threads on the rods quite a bit before...
  2. J

    FJ40 1975 2F Aftermarket Coolant Sender Location and Adapter Advice Request

    This is where I ended up for now. It’s too tall but I can tell you: -the 1/2”NPT definitely threads into the BSPT -a “1/2” NPT close short nipple” Would be better than the nipple I purchased. -a 40mm tall 1/2”NPT adapter would be ideal
  3. J

    FJ40 1975 2F Aftermarket Coolant Sender Location and Adapter Advice Request

    I just removed the square plug at location #1. Looks like it’s 14mm deep.
  4. J

    FJ40 1975 2F Aftermarket Coolant Sender Location and Adapter Advice Request

    great picture! How long do you think your temp probe extends into the block?
  5. J

    FJ40 1975 2F Aftermarket Coolant Sender Location and Adapter Advice Request

    Wow. From everything I’ve read on here they didn’t sound like an option. Did the adapter screw directly into the block or into the adapter hat the sender screws into?
  6. J

    FJ40 1975 2F Aftermarket Coolant Sender Location and Adapter Advice Request

    Greetings! I could use some help locating an aftermarket coolant temp sender and choosing an adapter. According to the research I’ve done on this site, I have found the following: Location 1&2 = 1/2” BSPT(top of head) -depth = ~14mm -if you use these locations with an oem sender you probably...
  7. J

    1975 FJ40 Heater Hose Cap

    Thanks guys! I think I’ll go ahead and plug it up. Not planning on running a heater and it will be nice to clean it up a little. Plus that lower tee was looking pretty rough. Right now I’ve got one of those rubber caps on the port at ‘A’. Maybe I’ll try to find a plug for that thermostat instead.
  8. J

    1975 FJ40 Heater Hose Cap

    Greetings! I’m in the process of replacing thermostat, water pump, coolant hoses, etc. The previous owner removed the heater and from reading on this forum I’m pretty sure he just rerouted the heater hose from A to B in the picture. My question is, can I just place a cap at A and B and remove...
  9. J

    Tranny to Transfer case bypass hose

    I could really use one of these in the 12.5” size. I sent shipmag a pm but it said his inbox was full. Can somebody help me order one of these?
Back
Top Bottom