Recent content by Jhitch31

Hello! I installed that Hopkins 43315 recently and thought i followed all the directions from here but have a problem. When I turn on my headlights, in the rear left, the yellow light lights up. The right rear, the red light turns on. When I press the brake the left yellow stays on and the...

Distributor. White wire coming out of distributor connects to white Howell wire. I think the white wire from the distributor was connected to an existing Toyota wire. All 3 of those got connected together. H- Howell D- Distributor T- black Toyota wire.

For sure I'll work on getting those together.

It seemed like the Sniper would have been way easier to hook up. The Howell took me hours. It was way easier with pictures from a fellow mudder. If I had that help from the beginning, it would have gone a lot faster. After being done, it might have been a headache, but $700 is also a lot of...

It actually turned out pretty awesome. I Getting all the wiring hooked up to the right places was very difficult. It seemed like every step was a challenge and took a lot of research to figure out. I also have next to no experience with wiring. I ended up finding someone on here that had...

Thank you. I think I have it figured out now. Any advice on the throttle cable?

Also, Howell's guy who helps on the phone is on vacation. I've tried calling them.

Hello! I have a 1984 FJ60 2F and am in the middle of the install of the Howell EFI kit. They sent me instructions for a V8 Jeep and online their cruiser instructions are very vague. I have searched high and low on here and found a set up for the FJ40. Does anyone have a diagram or, even...

Does anyone have pictures or a diagram of where the vacuum lines go on the Howell EFI on a FJ60 2F? Also a picture of how the throttle cable is supposed to look? I am somewhat smooth brained so am having trouble figuring it out.

I'll have to look those up. I have a k and n open air filter on the way that should fit. I'll let you know if I run into any snags. Thanks!

Thanks man it seems very overwhelming reading through the instructions. Especially for a novice. But I'll figure it out!

Awesome thank you. I will be doing that this week.

Did you ever get an answer to this?

Did you ever figure out what the issue was? Mine is doing the same thing. I have a carb rebuild kit in the mail. Wondering if I need a canister?

Ok cool thanks for the clarification. I think I'm going to pull my AI system. I have been trying to take the broken check valve off and can't get a good angle on it to get any leverage on it. I'm thinking I need to drop the exhaust to get it off.