Recent content by jestertoo

  1. J

    So I'm presuming I need a new front driveshaft

    I had a second opinion on the yoke and went ahead with ordering the replacement driveshaft.
  2. J

    So I'm presuming I need a new front driveshaft

    Sometimes it was just simply from trying it different ways to find out which worked best, if not perfect. Even after engineering, testing and trial and error is required with human subjectivity.
  3. J

    So I'm presuming I need a new front driveshaft

    https://www.amazon.com/Loctite-442-66010-Retaining-Compound-Silver/dp/B000O03DK0?tag=ihco-20 I found a used driveshaft on ebay for $115 shipped. They are supposed to send me pictures of it.
  4. J

    So I'm presuming I need a new front driveshaft

    91-92 have them in-phase, 93-98 have them 90deg out of phase.
  5. J

    So I'm presuming I need a new front driveshaft

    Thanks for the link. Closest one to me is 83 miles one way for $60. Sent them a msg to see if they will ship it.
  6. J

    So I'm presuming I need a new front driveshaft

    No plans to lift it. This is just a country road/around town vehicle.
  7. J

    So I'm presuming I need a new front driveshaft

    Can I use a yoke from a 1991? Does the timing of the driveshaft (in vs 90deg out) affect overall balance .. IE if I take a 91 yoke and put it on my driveshaft, will it be out of balance?
  8. J

    So I'm presuming I need a new front driveshaft

    Thanks. I missed it when looking through the forums.
  9. J

    So I'm presuming I need a new front driveshaft

    Looks like they are easy to find on ebay for $120ish if it's toast.
  10. J

    So I'm presuming I need a new front driveshaft

    Pressed the bad ujoint out of the front drive shaft. Went to install new u joint cup into the yoke and it fell right through. Fits fine into the other 3 holes (i.e. tight, wouldn't go in w/o press) so it's obviously bad yoke. Is soliciting here for someone's takeoff ok, otherwise, where might...
  11. J

    Is a 1/4" spacer plate ok on hub-centric wheels?

    That's what I was wondering. Thanks.
  12. J

    Is a 1/4" spacer plate ok on hub-centric wheels?

    Yeah, I'm not gonna buy real spacers. Just thinking a simple 1/4" plate between the wheel and the hub. I wasn't sure if it wouldn't mess up the hub/hub-centric wheel alignment.
  13. J

    Is a 1/4" spacer plate ok on hub-centric wheels?

    I put a set of taco wheels on mine and it looks like they could stand to be spaced out a small amount. Or do I need more, like 1" ?
  14. J

    FJ80 Noob

    So new to me set of tires and rims off a taco fixed the old tire problem. Pulling the front driveshaft and test driving it with the diff locked and the fuse pulled told me the front axle is good, just the bad u-joint on the drive shaft.
Back
Top Bottom