Recent content by Jccruiser87

Anyone have any good pictures of putting an x in the b-pillar hoop on a metal tech profile cage, trying to keep some leg room for my kids.

Redoing the inner fenders on the rear

Yeah I'm hoping I don't destroy it too fast when it's done

My main concern is my tailgate is about an inch too narrow, which I'm hoping my factory hard top will still fit also, as it is from my original tub. But ambulance doors make since, I can always widen my tailgate to fit correctly

Does anyone know if there was a width variation in the years of fj40s? My original tub was a 64 and I now have a 1978 and my tailgate is narrower then the opening of the new tub. The tub was in really bad shape so I'm doing rust repair.

I've had my 40 for years been knocking away at it and finally have found the drive to finish this thing. Probably had a thread from yrs ago but starting a new one. Rig is stretched to 108wb 14 bolt rear end King pin 60 up front, for small block np435 and 205 case. Will have to rustle up some...

Going to mount it this weekend. My last one I mounted right in the center above the trans hump but I'll take some time to map it out best. We'll see what happens.

Hey all, I'm re wiring my shell of a fj40 and looking for ideas of where you may have put a new fuse block. I was thinking in the glove box because it would be concealed well, but think it might be a pain to get at also. Thanks in advance