Recent content by JamieTheMonk

  1. JamieTheMonk

    80 series gearbox + transfer mod into HZJ105 with 1HDT

    I think I got clarification on the flywheel being the same physical size, just the dowels are in different spots for the relevant clutch. So having a 300mm wheel and clutch should work fine, which is handy...
  2. JamieTheMonk

    80 series gearbox + transfer mod into HZJ105 with 1HDT

    Hi Pilbara, That's some good info, thank you! Since posting this I've ended up getting my hands on a fairly new (2019, 110,000 kms) H152 box (taller 5th gear) from a VDJ79, so the scope has changed a little bit. That was taken with everything out during an auto conversion and came with a good...
  3. JamieTheMonk

    1HZJ76 flywheel replacement with a 300mm.

    This suggests it's OK... https://forum.ih8mud.com/threads/1hz-clutch-set-behind-1hdt.367756/#post-5345456
  4. JamieTheMonk

    1HZJ76 flywheel replacement with a 300mm.

    I've just picked up a H152 from a VDJ79 complete with clutch, flywheel and other bits, keen to know this for sure also before I go changing input shafts over to a shorter 14 spline HDJ80 input shaft!
  5. JamieTheMonk

    80 series gearbox + transfer mod into HZJ105 with 1HDT

    Hi all, I've searched and searched but I can't seem to find the info I need for this specific case... I have a 1HDT swapped 105 series pov pack, and I'm swapping out my R151 box (pushing 190hp and towing 2T so I'm being cautious) and have found an 80 series petrol H150 with full time transfer...
Back
Top Bottom