Recent content by HXE

These are the parts I ordered for mine from Serra Toyota Cost was $75 shipped in 2026 Bolt with Washer Part Number: 90119-08C47 QTY: 12 Roof Rack Bracket Front Part Number: 63185-42020 QTY: 6 Roof Drip Molding Joint Cover Part Number: 75596-0E040 QTY:6

Just to close the loop on this. I ended up sending the transmission skid back. Asfir was great to work with. For anyone that runs across this, the transmission skid will not fit with the stock gas tank skid, and Asfir will tell you that, not sure if they'll add anything to their website.

Ran across this seller looking for some parts for a project. Wanted to share in case anyone else has a need. https://www.ebay.com/str/serjio7mss

Hoping to get some input I picked up the Asfir Front skid plates and the Transmission & Transfer Case Skid. Front skid plate mounted OK but when I got to the Transmission & Transfer Case Skid it doesn't work with the stock gas tank skid. I've seen some people say it works fine, so just wanted to...

M6x1.00 confirmed for the next guy that comes in looking.

Appreciate the information. The old nut was a m8x1.25, this stud is smaller so I'm guessing it's a M6x1.00. Stainless steel felt safe, but I really appreciate the confirmation. I'll see what I got in the parts bin that will fit.

Replacing a no name alternator with a Denso 210-1056 The power wire stud is a different size, smaller than the one I'm taking off so the nut doesn't fit. The alternator didn't come with a new nut. Does anyone know the stud size, and can I just use any nut to hold the power wire on? Should it be...

Most of the green backlight in my switches were burnt out and I wanted an economical way to replace them. All the links I found for bulbs were defunct so I went on a search and found replacements.The majority of the switch backlights are a 3mm incandescent bulb with a green...wrapper.. on them...

Hopefully this post makes it a little easier for the next guy, there's a lot of wrong information on what this connector is and what you need to "plug and play" into the factory fog light harness. Recently I wanted to replace my original fog light housings with something that didn't look so...

I wanted to like these but for the money they just didn't fit well enough. I sent them back and got a refund. Decided to spend more money and get a permanent solution, of a mount and some after market pod lights.

Update for anyone thinking about these. I found a pair for around $85 so I gave them a try. The plastic clip on the outside of the housing meant to latch into the mount on the bumper was too short and not rigid enough to lock in. They were also missing the clip nut to secure the other side...

Any update on these after your long road trip?