Recent content by HueChak

  1. H

    SQOD Squad - Stupid Question Of the Day

    Many Thanks!
  2. H

    SQOD Squad - Stupid Question Of the Day

    Here's my SQOTD.... Removing the headrests to install seat covers, and there's a little white plastic piece on one of the posts. The manuel sez to push it in with a flathead screwdriver while pressing the other side in to remove headrest. Will that fall out when I remove the headrest or does...
  3. H

    200 Headrest removals?

    Any trick to pulling headrests completely out? Manual sez push a small screwdriver into the slot where the white tab is while pressing the other side and lifting out..... Just curious if that little plastic piece falls down the seat or any other tricks/tips to pulling it out and re-inserting...
  4. H

    SQOD Squad - Stupid Question Of the Day

    not really, 2nd row is for him, the back is for cargo, coolers, etc. that I keep strapped down....
  5. H

    SQOD Squad - Stupid Question Of the Day

    Red Heeler mix, facing what would be a big jump up, and not keen to have him jump down repeatedly. I looked for Budbuilt steps, but only saw Budbuilt sliders. Already have sliders, but those are to low to be of use fur the up/down.... Just into the 2nd row seats, and into the "hammock" that...
  6. H

    SQOD Squad - Stupid Question Of the Day

    I looked on this site, but didn't see anything. Added pix to my OP. Steps are too wide, and I thought about some sort of receiver that the step posts fit in(15" centers) and then narrows down to fit to the door landing, which is under 12" and not all one level. Or thought about some sort of...
  7. H

    SQOD Squad - Stupid Question Of the Day

    My SQOTD - Dog Steps? Anyone figure out a set of dog steps that will line up and fit to the 2nd row doors? (2020 LC200 HE) I bought a collapsible set of dog steps for my guy to get up and down in the 2nd row, but they are to wide. The doors don't open to 90 degrees, and the landing rods are...
  8. H

    SQOD Squad - Stupid Question Of the Day

    As a newbie owner I love this thread!
  9. H

    LX570 3D printed cupholders!

    if this will fit the LC200's then take my money!!!
  10. H

    Anyone replaced their stock 200 series car horn with something louder?

    https://motohorn.com/dual/ was also considering the Motohorn motorcycle version, as it might be easier for mounting positions......
  11. H

    What dashcam are you using in your 200?

    .... Was looking this up for my LC, saw these all over FB, etc... anyone have any experience with these? WOLFBOX G900 TriPro Bumper Version 3 Channel Rearview Mirror -...
  12. H

    New to me, 2020 LC HE

    Happened before my purchase so don't know.
  13. H

    New to me, 2020 LC HE

    Thanks. Will do. Got the ultimate dog wagon now, so planning on lots of fun trips!
  14. H

    New to me, 2020 LC HE

    I bought it how I found it. No info on how/when it happened
  15. H

    New to me, 2020 LC HE

    Thanks. Lucky for me I had mechanic friends in LV who could inspect it for me, plus they new the prior owner(2nd). Had to have it after it all checked out.
Back
Top Bottom