Recent content by Herrett

For my 1997, I need just the two wire pigtail for my oil level sensor and a new brake line from the T to my ABS controller. Local small town mechanic shop couldn’t find the parts. Any idea where I can source them? Thanks

Well, it’s now been over 6 months and the door handle is still solid. I’m a happy camper.

Well, it’s been over 30 days since I fixed the door handle with Epoxy. Ive used the handle to shut the door countless times each day, so I think it’s going to hold.

Thanks. Not an off roader except for lots of hunting and fishing trips.

One more. Middle seat storage.

Here you go.

I talked with Dave as I’ve ordered other parts from him. Hood insulation is a problem due to size, shipping and potential for damage from Japan.

Thanks. I’ll be on it next week.

Thank you!

I need to replace my hood insulation. By its nature of being large and thin, can on line vendors ship it without lots of damage? Thanks

Thanks for the 3D printed products Lee!

Posting this for the new people on the forum that may not be aware of the storage module 4x4 labs makes to replace the 3rd seat bracket over the wheel well. They are very stout and well made. On the other side, I’ve covered the holes from removing the brackets with Solvefunction 3D printed...

Thats a good idea too.

I hand packed epoxy into the cavity, insuring it got behind the washer and engulfed the screw. Also by packing it tight I wanted to adhere to the sides of the cavity. I removed the masking tape an hour ago and it seems rock solid.

Here’s the fix. I’m letting it fully cure before clean up and removal of the masking tape. Time will tell if it holds. Again, I used a longer screw that extended into the cavity with a washer on the end to add surface area I don’t think you will notice anything due to the position of the...