Recent content by Gunrunner235

Would a leaky cap or leaking reservoir cause foam or frothy PS fluid? My PS whines like crazy n froths up, I replaced the cap, but I’m still getting some kind of leak from the reservoir, I put white tap around the upper o ring lip and doesn’t appear to be leaking from there, I think it might be...

So, found out I have a leak in the plenum gasket, I’m pulling the upper off when i get the parts in, but under there I know are a bunch of VSV and VCV, I know some are related to ERG, I was getting the code a while back but did the resistor fix and now don’t really need a lot of these under...

So….. think I finally found my cause, is a bad intake gasket, the upper to lower. Here is what happened, ordered new silicone hoses, replaced all the hoses, now the trim jumps to 19.5% immediately at idle, levels out to like 1-4% while driving. So got some carb cleaner and started spraying...

so I reset the ECU or PCM, my truck is re-learning, took about 15 mins of driving to get the fuel trims to show up. STFT- between 0-7% at idle, usually negative number while driving, LTFT is at 30% while at idle and around 8% while driving. From my understanding the positive percentage is the...

So a little update, cleaned the MAF checked again for leaks, cleaned all the contacts on the MAF connector, sprayed around with starter fluid, no revs, did a smoke test, nothing obvious, I did find the PCV grommet was a cheap Chinese POS and torn! Replaced it and ordered a new PCV. While the...

No. It’s just normal gas motor

I will do a short video of the live data I’m getting as far as fuel trim.

got my new rad in! Finally fought me most of the way, realized my torque wrench was no bueno, ugh, well it’s in, new belts, man I had those cog ones on before and my truck sounds so much smoother now, swapped the fan clutch seems to run good no leaks I could see after running for like 30 mins...

Only 1 landy in Abq at the yard, and it’s been gutted! Lol. Reminds me when they had a 04 Corvette and I went there to get some trim pieces, I got there and it was literally the completely gutted frame and the empty cab, I did the smoke test. No leaks, which vacuum are u talking about the brake...

I removed the intake hose n looked at it looks good, did a smokers test and no leak I can see, cleaned the MAF last night. Gonna cut the tape on the wiring n inspect it, I will advise what I find,

Above are the clips I’m missing, I added some fuel treatment to the truck, while I was waiting for my kiddo to get outta school I did notice a pretty good idle stumble, happened a few times, seems like maybe a misfire but no codes came up, but the idle would fluctuate about 100-200 rpms like it...

Ya I was worried it might be the harness, bc what cleared it the first for me was I noticed a kink in the harness from the wall to the MAF, I re-soldered the wire n re-secured the wires n wrapped them in heat shield n the code went away for 6 months. I’m replacing my radiator, fan clutch, n all...

Was out messing with my truck, still trying to solve my P0171 issue, anyways, started to tear down the radiator lines and saw this hose, I recently replace the one right in front of it, but looks like I might be leaking from this one too, what is this called? Size etc? Biggest leak is from the...

Ya I’m gonna do another smoke test, and clean the MAF today, I was watching a video some guy says he was getting pressure in his tank, when he opened up the fuel cap would here pressure release, mine does that too, he said it was causing lean running bc it created a vacuum in the tank, he...