Recent content by gregkline55

Dupli-Color Ford Gray engine enamel, just went and looked

I believe it was ford gray or industrial gray, cant remember off the top of my head

Got the driveshaft moving along, its shortened, phased, and tacked. I'm going to have one of the pros in our shop weld it up for me next week.

On lunch today I started the process of shortening the rear driveshaft, tossed it in the lathe and got the big end yoke out.

Started digging into the rust on the body of the truck, some real fine craftsmanship from one of the POs body guy.... But slowly stripping it back to find good metal so it can be built back. Need to get my hands on some replacement panels, curious where most people go to for the...

The wife travels to Saudi frequently (in Riyadh as I write this) and seeing these makes me want to tag along and find one to send home... these 75s just seem so damn good, plus it would be perfect on the farm. May need to talk to your contact in the future haha Looking great as always!

Found this in the trash this past weekend, cant believe someone would get rid of this thing! Its in amazing shape, not a single issue with it, has a build date of 12/76.

Finished removing the rest of the factory sound deadening, still have to remove the rest of the aftermarket stuff which isnt fun to remove. The newer stuff was put in poorly and definitely was holding moisture in some areas in all I only found two areas that I didnt know about that need fixing...

I believe the mosely PS line is meant to work with the pump with the reservoir attached not the style you have. Im sure someone can get the proper fitting on there though

Looking for a few things: - washer/spacer that goes in the lower radiator mount bushing, need 1 - Front body mounts that go between the lower radiator support and the frame - Brown carpet, just the front section, if in decent shape

Where are you at? I saw this locally on FB marketplace, always fun finding other local 60 people

Lots of progress this weekend, biggest thing was getting the main chassis harness back in. Finished adding in provisions for cruise control and other accessories, wrapped it all up, and got it pulled back into the truck. I then could (almost) finish terminating everything to link back into the...

Did a test fit of the relay panel today, super happy, fits exactly as it should. So getting closer to having the wiring all finished up, engine harness just needs a few more wires terminated and the bundle going to the TAC module needs to be shortened. From there its just wrapping it in loom and...

So designed up a mount for the electronics in solidworks and sent it off to SendCutSend, it mounts on the side of the fender. This will house the RTMR, bus bars, and main ignition relay, there is also area for two additional relays if needed down the road on each side. I have a cap for it too...

Sent you a PM