Recent content by graymudder

I have the same p^roblem with my idle speed. I noticed that my kickdown cable is not connected. Would that cause the issue ?

Taking the window down will be an issue onto itself. Lets just say I cannot get the window down. But that thing is not moving up , down or sideways. Will soak it with penetrating oil and see if that helps.

I have been trying to remove this upper safety bar , All bolts removed but its wedged in there and I cannot get it off. Any help .. What am I doing wrong.

I am in need of information. I have the dash light number 6E194 these are the bulbs for the gauges and speedo. I see a resistor in the back of the gauge cluster but I have not traced the circuit. My questions ; Is the resistor for the Amp gauge ? Are the 6E194 bulbs 24 Volts ? Thank you

I am doing a fully fused system. Once I have gone through the diagrams and drawn the actually component placement I will update my diagrams with the components and part numbers and of course pics of the items..

Hi Looking for a radiator for a 1982 BJ42 (in good shape or not ) . I will recore here at my location. ( New Brunswick, Canada) PM me..

I will post a list of the components and their part numbers and where I got them (most from Amazon) Ahh the bulbs are all LED (hence the LED electronic flasher) I have the part numbers . But I will do a test fit , as I see maybe a small problem with the rear lights assy. The LED bulbs might be...

Here is what I plan on doing.. I have 2 diagrams. ( I am not a designer nor do I understand the electrical symbols. This is free hand). If you see any discrepancies be gentle ..

Here are some of the horrors that awaits me.

I found a shop in Moncton New Brunswick, MR. Starter and Alternator, who is willing to work with me to fit a 24 volt Delco 1 wire 10Si. I will post some pics in the next days. I would take the pics today , but we are in a snow storm (not really buts its snowing steadily) and its 0 Celsius ...

I am trying to, but not sure they can get parts for it and I also wanted to rewire to have a single wire exciter. Internal regulator and rectifier

I need to replace my alternator and the voltage regulator. However I am not spending 1000 CDN on alternator and I still need an external rectifier and voltage regulator. There are 24 volt 10Si single wire alternators. If I have to machine a bracket then so be it. As for the single wire that's...

Well here we are 1 year later and this year its colder than the North Pole. I have to thank the community with such great ideas. Going with 2 12 V batteries, bring everything back to 24 volts. I did have her running in Nov before putting her in the garage. So now I dig into the wiring loom ...

Thank you..

well here is what triggered me. When cold usually well below -20 C after a few minutes the temp warning light comes on for about a minute or so and goes away. The truck is still in the cold range. At first I thought it was a cold water indicator as well, but notice that the light comes on...