Recent content by GrapeApe9

The LC has 205k miles but there isn’t noise nor leaks, but I’ll dbl check, so I prob will just leave it as is. Glad you mentioned that as I was assuming it was a regular maintenance item like the front.

There are a few YouTube vids with LCs that appear similar but apparently different, perhaps 105 series, with rear bearings like my fronts. I was hoping that’d be the case. I don’t have a press, but otherwise this appears doable despite my limited experience. Thanks for the quick reply, and...

On my 1999, 100 series, LC I replaced the front wheel bearings, now I want to do the rear. I’m not sure which parts to order. Are the rear hubs similar to the front having an inner and outer bearing and races? When I google for the rear parts/kit, I’m getting just the front bearing kit or a...

I’ve searched but didn’t find any info on turn signal being out on just one side and no emergency flashers. On my 1999 LC the passenger side turn signal is not working, also the emergency flashers are not working. I’ve checked both the front and back bulbs and they were not blown, I replaced...

I did work on both shafts, then drove without the front DS. But had same issue. I hadn’t tried driving without the rear yet b/c I wasn’t able to find any definitive answer by google searches... I’ll give it a try - appreciate the help, thank you!

Good to know, thank you!

Unfortunately it’s not lifted. Thanks.

I’m trying to isolate a vibration, felt more in seat but also in steering, on my 1999 LC. On both driveshafts I had the ujoints replaced and shafts balanced at a machine shop. After which the vibration decreased but is still present. Before I would notice vibration at 35mph and up, after the...

Thanks for the diagram! Here’s what I tried...created a tight seal with the shop vac onto the metal tube coming up from the engine, as suggested above. Then quickly hit the on/off button a few times. This drew out one small plastic piece, but not all. So then I tried several prolonged vacuum...

Ok, thank you both! The LC is sitting in the garage with things still torn apart. So I’ll give the shop vac a try. Thanks again, appreciate the advice!

I was doing preventative maintenance on my ‘99 Land Cruiser by replacing the plastic T’s on the coolant lines. I eventually got the clamps backed away, and the first T removed intact. The 2nd T, closer to the driver side, broke inside the hose that goes to the engine. While trying to get the...