Recent content by goldman

There were different roll outs of different models throughout the world. So, even though I don't know exactly the answer to your question, its not uncommon to see some variance in the world market versus the 60/62 models that we know here.

well that was anticlimactic, I was waiting for an explosion.

Did you look at the door plate. It’s on the driver side b pillar and has the manufacture date. At least it is on mine.

we don’t have the white stuff down here. But plenty of red clay.

Did they replace the belts during the tune up? My belts shed some rubber and smelled For the first couple of tanks after the belt change.

Im running the same suspension and have 295/70r17 toyo rts on mine. Toyo says they are 33.3 by 11.8, I get the slightest kiss of a rub at full articulation and full turn.

no, you can't see it great in that position. Im redoing my dash in the future, so for the time being I just stuck a sheet metal screw through the bracket that came with the sniper. And like I commented I was excited to block the choke pull. I think the optimal position is going to be where...

I mounted mine right over the choke. Wont be needing that anymore.

Yes. Stock ignition system.

I did the tach wire on the negative side of the coil, works fine. I also did the ignition positive to the positive side of the coil and has worked fine. The instructions say to attach the negative to the coil. They say not to put the positive to the coil, but I couldn't come up with any real...

Hella lights up front and I did the odd iron dome light led kit. Which is also awesome.

I went with the medium OME in the back and the heavy up front. This resulted in the rear fender being 1.5 inches higher than the front. I wouldn't go heavy on the rear unless you are planning on having a lot of weight back there. I went heavy on the front due to the bull bar and winch. medium...

Next was the sniper efi. If you are considering doing the efi upgrade, just do it. Man it is awesome. And we lost a little weight along the way. I was going to do a more detailed build but time hasn’t allowed the documentation to happen like I wanted it to. Another thank you for all you...

It’s been a while and a lot going on. I’ve done a lot of work on the old girl. new wheels and tires. Toyo rt 29570r17. Fuel shok 17s. then I went on to a new arb bumper andwinch. Just put a cheap harbor freight on there for now until I can find an 8472 to rebuild. next was dealin with the...

I just replaced both my slave and master yesterday. Same symptoms, started last week, I pulled the master last week and bench tested it, it started working, a week later the symptoms recurred so I replaced the master, slave and the flexible hose. The total cost was about 70 bucks from rock...