Recent content by GFL

Everything looked good. Clean, bright metal no signs of heat ...

Your points are excellent. In my case every time it failed if I cleaned or replaced the EFI fuse it would start and it might be good for a month or maybe only one start. The last time I replaced the fuse, it worked for about a week and failed and this time the fuse was burned out and black on...

Yes, after removing the four mounting bolts, you can lift the fuse block up starting on the engine side. You can lift it just enough to remove the first four 'plugs'. Then working my way through each row, I had to remove a total of 11 plugs. With each row you will be able to lift it a bit...

I tried finding information on the internet without any success. There are sites that purport to offer pdf repair manuals ... BUT I tried accessing a couple of them and my anti malware software id'd them as trouble. They want credit card info to pay for the download and I was not willing to...

Installed fuse block assembly (82720-60023). Started right up so we will see if this fix lasts!! I had difficulty removing the old and installing the new. It took me at least seven hours. I think there are specialty tools that would make the task go faster.

Bitten again and this time new fuse, jumper ... doesn't resolve the problem. Have ordered new fuse box/panel but find no info on removal/installation. Looking for a diagram and instructions. Any suggestions? Any tips on what not to do?

Follow-up on earlier post. Today the immobilizer struck again and left me immobile!! Anyone have info on disconnecting immobilizer! That is my first choice. Second choice will be replace fuse panel. Any advice on where to obtain and part number ...? Thanks in advance for your help. garry

2002 would crank but not start. Had it towed 30 miles to nearest Toyota dealer and they pulled it off the flatbed and it started up! They had it for a couple of days but it would always start and they had no advice as to what it may be or what I might do should it happen again. I picked it up...