Recent content by feverDream

Us oldtimers were calling them FJs for years and then the cruiser came along and ruined it. ( ﾟーﾟ)

I'm probably being waaaay too OCD! I may just use some universal blue but @dbbowen may have something with using the FIPG

It's a walk in the park-one of the first projects when I got my 60. My Desmog Keeping HAC Lots of Pics - https://forum.ih8mud.com/threads/my-desmog-keeping-hac-lots-of-pics.440288/

here's the 2 worst offenders. the first picture is the worst and of course it's located at 06:00. second picture is at about 11:00

crazy how small the FJ looks back-to-back with the FE

thought I'd start a new thread instead of piggybacking on a dead one that wasn't specific to this question. Had a bad leak on the pumpkin side of the rear axle, figured I'd toss in a locker while at it. Getting ready to button it up and upon cleaning the surfaces I noticed the PO decided to...

I am in need of a idle mixture screw (the one with the spring on the passenger side of carb) I've tried multiple parts houses and nobody has them anymore. I even tried toyota of Japan to no luck. it's for the stock 1986 Aisin carb. I have a trollhole on the rig now and the old Aisin is taking...

Whoops! In my excitement, I totally missed that. Must be a corolla motor

I snapped some screenshots from instagram, most of these were in video format so pardon the blurry shots @GasganoFJ60

I have seen scale model kits of various engines over the years but I saw a 2f model on a middle eastern toyota dealer's instagram feed. It would be pretty cool to find one, Anybody ever see one? I tried googling it but no luck...

do you mean keep the bearings and shims intact and just replace seals alone? Getting prepared for this procedure too and in the process of collecting info.

pretty even all the way around. sounds good-needs to be done anyway. wanted to do an OME lift and use the shocks from the kit but I think I'll go your shock route

I have some bfg all terrains on my wagon and I'm noticing some strange wear on the passenger front. No odd vibrations, weights are still on, tie rods good except for one on the passenger side but I'm not getting play when I rock tire at 3 and 9 o'clock. Shocks are pretty much toast I think, and...

@spencer arndt if youve got the tool elastic, you can add that to the hold down

replaced diff fluid in the rear, greased driveshaft slip, greased u-joints, swapped out fill and drain bolts with allens from toyo dealership. Talk about a pain: the fill was totally locked on and heading towards stripped. Heat, PBBlast and impact with a ground down 15/16" finally got it free...