Thank you! I have no idea what the front bumper came off. I know there was a 2” gap between top of bumper and bottom of fender. I had to cut and relocate the brackets on the bumper for it to fit properly. I sent pics of it to a salesperson at ARB and he said it looked authentic, but he couldnt...
i should have given more detail. I know i said in the thread title “FZJ80”. I know this is an FZJ80 rear housing. I do not know what year it is. I am refurbishing it, installing an ARB air-locker and putting it under my ‘92 FJ80. These backplates looked as though they were warped. I couldnt...
I believe this part would be called a rear backing plate. The brake components mount to this. Does anyone know the part number or where it would be available? I need right and left side.
So, in a bit of interesting circumstance, our normal, full-size, domestic farm truck ended up in the shop for months while in for repairs. The technician doing the bodywork came down with the flu twice, and pneumonia. The Farm 80 went into full service as our primary farm vehicle around the time...
It was paint swapped by a PO. Based off what i can tell, during the repair of a crash to the passenger front door. I would have left it the factory metallic blue/grey color. The front bumper was on it when i bought it as well and was 2” too low. I modified the mounting brackets. I have no idea...
Are you in HOTSouth? I am a new member this year. I have thought i needed help many times along the way. I usually have been able to figure a way to do most of it on my own or with the help of my wife, however, you never know what you may run into. I bet the rear axle swap is going to be...
Here is a more recent photo of the engine bay. I installed an aluminum radiator and otherwise tidied up most of the loose ends here. I plan to use the second battery for the winch, compressor, and stereo power, at least. I may run the batteries in parallel through a controller or something. Not...