Recent content by enui

  1. enui

    1PZ - swap for a 1HD-FT ...will it fit?

    I'm in the same boat at the moment with a lx trim 1990 pzj70 in New Zealand with some engine issues. Where bouts in New Zealand you based because if you end up selling the damaged motor I could be keen to buy it. As for an engine swap I've been researching quite a bit on this and there's a few...
  2. enui

    R151F rebuild and upgrades

    That sounds bloody good, I'm based in dunners but I'll have a chat to him. Got any contact details you can dm me?
  3. enui

    Pzj77 Build. That will probably never end.

    These are the 2 guys trucks I've talked to who've done the 80/gq axle swap
  4. enui

    Pzj77 Build. That will probably never end.

    Ha I came to the same conclusion after talking to the cert guys Interesting you've gone that way. I've talked to a couple guys who've done the 80/gq axle swap and it seems like the way to go. Have you seen Ethan's pzj77? It looks just like yours but it's had the 80/gq axle swap, 1hzt swap, and...
  5. enui

    R151F rebuild and upgrades

    So I'm looking at rebuilding the gearbox in my PZJ70. I'm pretty sure it's a R151F (someone correct me if I'm wrong). I'm wondering if there are any upgraded parts that are better than the stock toyota ones that I should install in it. I've had a look at some marlin crawler parts and short...
  6. enui

    Pzj77 Build. That will probably never end.

    Is your truck certed? Also I'm a bit new to this but what exactly is a ifs hub conversion and how do you go about doing it? I was planning on running spacers but this seems like a better way. Also your truck is looking sick with the intercooler setup. How does the 1pz go now with it? How much...
  7. enui

    Pzj77 Build. That will probably never end.

    How's the 1PZ go with the CT12b? I've got a PZJ70 I'm looking at doing similar work to you to. Is your mates coil sprung swb prone to tipping over? I've noticed that mine wants to lie down on its side a lot while offroad.
Back
Top Bottom