Recent content by elemenohpee

I can also break this down flat to ship it or I might be able to deliver in the PNW area. Just shoot me a message and we can figure out the details.

I built this a few months ago to store my fridge in the back seat for quicker access. I'm moving to a heavy bear area next month and I don't think I'm going to use a fridge nearly as much, so I've decided to let this go. It fits an Iceco vl45pros perfectly but should work with pretty much any...

3d printed a sleeve for my swing arm latch so that it can accept standard bike grips. The longer length of this makes things so much easier and prevents me from slamming my hands into the locking pin.

Let me try to find a box and then I can start getting shipping quotes.

Trying to avoid having to box this up and ship it, but I’ll let you know if that changes.

Ordered from Kaon in Australia about a year ago and it's still in like-new condition. As you can imagine, shipping was not cheap, but it was worth it to me due to lack of other options. This is an awesome cargo/pet barrier with lots of attachment points for gear. The included brackets will only...

Sorry, no shipping for now. I'd like to not have to deal with that.

Both in pretty good condition. Minor surface rust on both. Front skid is a bit worse but could probably still be cleaned up. Hitch - $50 Front skid- free

Yeah it's a US truck with no frame repairs/modifications as far as I can tell. I should have taken some better photos after I cleaned off all that dirt. Here's a photo I found online that looks exactly the same though. There's no openings on the top or bottom. This appears to be pretty standard...

Yeah I've already been exchanging some emails with Slee. They've acknowledged that these bolts won't fit and their recommendation is to just not install them. That's now a total of 6 bolts that won't fit though... I can't help but think that surely all these bolts were added for a purpose...

I ran into an issue when installing a Slee rear bumper on my 2003 Land Cruiser. I have the rare pass through hitch crossmember that is more commonly found on lx's. I think the frame must also be a bit different where the crossmember connects because the Slee instructions make zero sense...

There's a very little amount of sag that's only noticeable when closing it. The swing out hits the plastic pad/rest slightly lower than before if that makes sense. I think it's a combination of the swing out and the bumper as a whole flexing a little bit. I also still need to figure out a way to...

I paid someone to weld a 2in receiver to my swing out. Pretty happy with how this turned out, but damn is it longgg now. I could mount the rack in a few more inches if I don't care about folding it up all the way though. The latch just barely clears the 1up locking pin. I'm going to look for...

I'm by no means an electrical expert, but I'm planning a similar install with an Orion XS and have been doing a ton of research. Take this with a huge a grain of salt... You could connect a bus bar between the DCDC and aux battery pos wire. In my case I plan to use a Blue Sea SafetyHub 150 to...

I recently found a good deal on a Slee single swing out rear bumper that I just couldn't pass up. This thing was heavily neglected though and the swing out bearings were completely rusted out. Over the last few weeks, I rebuilt the spindle with a Slee kit, gave it a fresh coat of paint, and...