Recent content by deadlew

Do you have pictures of the crawl box installed? PaulC

👍

I have one from an '88. PaulC

I have one from an '88. PaulC

PM'd you. PaulC

Where are you located? I have a set laying around. PaulC

Still have the adapter?

The Ruff Stuff Toyota 10.5" is ready to go in. Raised the axle coil spring mounts to eliminate the coil spring spacer on top of the springs. Used Ruff Stuff link and shock mounts to help speed up the process a little bit. Just waiting on the axles shafts to show up from Moser Engineering...

Some updates on my Tundra 10.5" build.

I'm using 14 bolt spindles and hubs (drilled for 6 lug) so I can use the 80 series disc brakes. For axle shafts I'll getting Moser Engineering shafts made with 35 splines and 14 bolt flanges. PaulC

More progress on test fitting parts, RD146 with Dana 60 side gears. My friend loaned me a front inner Dana 60 axle shaft. Fit well. Time to get the diffs set up and measure for shafts. Dana 60, 35 spline, front inner axle fits like a glove inside the Toyota 10.5" ARB. #dana_60...

ARB p/n 728K041 (Dana 60 35 spline spider gear set) will fit into RD146. I have a Ruff Stuff housing, with 14 bolt spindles and 6 lug hubs that I'm building. PaulC

(5) 15x10, 6 on 5.5", 3.5" back spacing, Land Cruiser hub cap clips, galvanized steel wheels. (2) front hub caps, and (2) rear hub caps. The wheel haven't had tires mounted on them. $250 located in Poquoson, VA 23662. I am going to Rausch Creek in PA Jun 24-27 and I can meet up on the way...

Do you have the 3rd row seats for it? PaulC