Recent content by dcraig1000

  1. D

    wiring nightmare

    i tried grounding it both ways, no difference. could it be because the coil is new, it doesnt have any built up capacitance?
  2. D

    wiring nightmare

    okay ,after buying a new accel coil, running a jumper from battery+ to coil+ and then momentarily grounding out coil-, i get an extremely weak spark to the block from the ht coil wire. you almost cant see the darn thing. so now i will wire it to the vehicle with ignition key start wire to coil+...
  3. D

    wiring nightmare

    :bang:okay, i tried that, and the only thing that sparked was the wire that i used to momentarily ground the - side of the coil........question, does the coil itself need to be grounded while doing this? i just have it standing on the fender apron while doing this....
  4. D

    wiring nightmare

    okay. Im just trying to get spark, any spark from the coil, once that happens, then i will introduce the igniter and ballast resistor into the system. i have the start wire going directly to the solenoid. i have the black/yellow wire going from the ign to the + side of the coil, and a wire...
  5. D

    wiring nightmare

    so, if i use the old ignitor(assuming it works), red would splice in to "key on", black to the dizzy, and yellow to the - side of the coil?
  6. D

    wiring nightmare

    how about if i put a flamethrower coil on ans just wire it up like a regular points setup?
  7. D

    wiring nightmare

    someone out there has to have the same set up I would hope.
  8. D

    wiring nightmare

    oops, fprgot the pic!!
  9. D

    wiring nightmare

    okay here is what i have. note the only wires that connect to anything are yellow, black and red(the sleeve is covering the color) so how the heck do i get spark from a semi transistorized ignition system?
  10. D

    wiring nightmare

    its a points dizzy. i will post a pic of the ignitor this weekend sometime, but i know it only has those 3 wires.
  11. D

    wiring nightmare

    okay, lets say i have the painless kit wired correctly for the ignition. how do i hook up the ignitor? i have a black wire, an all yellow wire and a red wire. thats it. my coil positive post has the 12v ignition wire on it. the coil negative is going to the only post on the dizzy. what else gets...
  12. D

    wiring nightmare

    hi guys, Im trying to rewire a guys 1975 fj40. starting with the engine bay. namely the ignition right now. what a mess. i have the ignition switch wired and i can get the engine to crank, but i have no spark. ive tried different combinations of coil hook jups ans nothing works. im not getting...
Back
Top Bottom