Recent content by dbrogdo4

  1. D

    tranmission noise! What could it be?

    If your noise is still around, you might want to check the Ebrake drum and see if it is getting warm to touch. I had one vibrate at highway speeds and start dragging. There are several springs and shoes that tend to move around. Try and release the tension on them with the adjustment...
  2. D

    Tranny Problems!

    Pin_head, After removing the floor and looking around in the tranny, I went fishing. I found the small pin that fits in the shaft at the end of what I believe is the thrust washer. It was in the bottom of the case. It must have fell out when I assembled it. The syncro seems to have just...
  3. D

    Tranny Problems!

    I'll start checking stuff. This is a travel week for me, so it maybe the weekend again before I get to lift the floor....Thanks again..
  4. D

    Tranny Problems!

    Guys, I believe you are correct in assuming the problem is at the top, where the shaft fits into the linkage. I took the shifter cap off and could here it hitting, as I tried to shift into 2nd while moving. It does not look like the area below the cap and spring is bent, but I believe the...
  5. D

    Tranny Problems!

    Thanks guys for the suggestions. A few additional tid bits. After driving about 50 miles in the last couple of days, I have noticed a pattern. When I come to a stop, I have to shift to 1st, before it will allow me to shift down to 2nd. Almost like it has to reset. It sometimes will go...
  6. D

    Tranny Problems!

    No I left the linkage alone.
  7. D

    Tranny Problems!

    Sitting still, every gear shifts from 1st to 4th. Starting off, I can start in either 1st or 2nd and then go to 3rd and 4th. I can not hit second gear while moving. I will try to go from 2nd to 1st tonight when I get home. Thanks for the help.
  8. D

    Tranny Problems!

    Thanks for the response. I might try heating up the RPMs and giving it a go. Any help is appreciated..
  9. D

    Tranny Problems!

    Thanks for the response! I did not replace the brass, just put them back in place (I thought)...What a pain to drop the tranny again. If I got to remove it again, I might just figure out how to adapt a 5 speed back in its place. I have 90w in the case. Would it help to put synthetic or any...
  10. D

    Tranny Problems!

    I just rebuilt my 4 speed transmission with new bearings and gaskets. Put it back together and installed it back in my 76' FJ40. Ever since then, it will not shift from first to second gear while moving. I can start in 2nd and go to third and fourth. I can also start in first and go to third...
Back
Top Bottom