I am looking for a master cylinder level sensor connector for a 1990-1997 FJ80 that will fit a master cylinder like this. Would like plug and a few inches of wire.
Looking to buy a ‘90-97 Landcruiser (FJ-80 and FZJ-80) from differential. Gears do not matter as I will be gearing. I do not need a locker as I will be putting one in. I would also be up to purchasing a front differential housing.
Sorry I never answered you! It all runs great now yes. I had a few hiccups for awhile. My 7th injector kit came with a faulty part that wasn't letting it run correctly but that was fixed with some easy troubleshooting. I ran into some overheating issues but that was fixed with a bigger radiator...
I also had some time last night to start tearing my new rear axle apart to get ready for gears and the electric locker. I forgot how much I dislike the smell of gear oil.
My switches finally arrived for my upcoming upgrades. I am using a paranoid fabrications 1st gen Tacoma switch bracket that I modified a little to fit. With the switch bracket installed there was still a small gap on the radio bezel so I cut a small piece of aluminum and taped it to the bottom...
So I am finally getting around to updating. I used a few other forums for my build but it seems this forum has the most engagement so I will be continuing on this forum from now on.
What is coming up
1. I purchased a complete rear axle from an 88' V6 Toyota Pickup. I will be swapping the stock...
front II by DayBowBow posted Jun 27, 2018 at 7:42 PMScoop by DayBowBow posted Jun 27, 2018 at 7:42 PMInterior by DayBowBow posted Jun 27, 2018 at 7:42 PMEngine by DayBowBow posted Jun 27, 2018 at 7:42 PMbumper by DayBowBow posted Jun 27, 2018 at 7:42 PMFlagstaff by DayBowBow posted Jun 27, 2018...