Recent content by Damothedevo

  1. D

    1hz rear main seal housing looks incorrect/offset.

    Yeah its a mega pita. Looks wrong but can't get anyone who has seen it before. Car on blocks got to put it in.
  2. D

    1hz rear main seal housing looks incorrect/offset.

    Hi mate, sorry for late reply, just wondering what the second picture is here, looks like the end of the my crank shaft but separated, isn't that part of the crank or is it taper fitted somehow?
  3. D

    1hz rear main seal housing looks incorrect/offset.

    Thanks for reply, i don't think it's the crank, i actually got through to toyota parts and guy was very helpful, checked part numbers of housing, compared to 1hd motor and even cross referenced with 100 series, all part numbers the same so think I'm gonna just put it together as is, hope doesn't...
  4. D

    1hz rear main seal housing looks incorrect/offset.

    Thanks for reply, it doesn't come out on pictures very good but you can see crank is not in center of seal housing by a few mil.
  5. D

    1hz rear main seal housing looks incorrect/offset.

    Thanks for reply I tried crank but couldn't move it, also engine ran smoothly. Definitely think its the holder, but not sure if just wrong one.
  6. D

    1hz rear main seal housing looks incorrect/offset.

    Thanks for replys, seal isn't rolleed its like the housing is offset hard to capture in pictures. I measured seal and is even all round, and when putting oon crank sits correctly until seat housing then gets pushed up.
  7. D

    1hz rear main seal housing looks incorrect/offset.

    Hi all, I'm doing a rear main seal on my 1hz, but seal housing looks incorrect, (see pics, can see gap at top) motor is second hand and has leaked from word go. Was wondering if 1hdt and 1hz have differences in crank or bearings causing 1hz crank to sit lower. If so i will order correct housing...
Back
Top Bottom