I have these leftover from my old wheel / tire set. Maybe someone here can use them. They are in good condition with no major flaws or damage. However, they are 22 years old, so it's not like they're brand new either.
Let's say $60 for the set. Located in Denver, but can ship necessary.
I have a set of 4 16" wheels off an LX470 that I no longer need as I'm moving to 18 inch wheels. They are in excellent condition. They currently have Michelin Defender LTX tires from 2017 on them with about 5/32 tread. The tires are located in Highlands Ranch, Colorado, a south Denver suburb...
Hi, folks. I had a problem with my ABS system on my LX470 in late 2019, which was initially diagnosed as the accumulator, so I replaced it. Subsequently, the problem persisted and I replaced the entire master cylinder assembly, which meant I got a new accumulator. Thus, I have this redundant...
I need an AHC accumulator pump, the one on the bottom on driver side not the one in the engine bay. If you have this, I would like to see a picture of all the connectors. Please send a message.
Hello. I want to replace the upper tail gate on my 2000 LX470, which is in the bronze color.
Please message me with what you have and how much you're asking.
Thanks!
I thought I might add one small thing that might be useful. I just did the repair of my front passenger door actuator assembly as well as the rear hatch actuator. For the rear, I used the Mabuchi motor and that worked fine. For the front, I wound up replacing the entire assembly. Probably...
Hi, guys. I was able to complete this repair this evening. Took me about 1 hour to do it.
The hardest part is to unscrew the third screw. Rather than use pliers, which I couldn't get to work, my tip is to go to Home Depot and by their offset philips screwdriver from Husky for $4.97. I...
I just did the seat bottoms on my 2000 Lexus LX470 and my upholstery guy said all but the interior panels were vinyl. I chose vinyl to for the cracked panels because it matched the best. You can see the before and after below.
The details are as follows:
$36 for 1.5 sq yards of automotive...
Talked with a paint/vinyl guy yesterday at a local shop in Denver. He says that old ouch up paint and other pre-existing flaws in paint will show through the vinyl wrap and didn't recommend going in this direction. I think I've come to the conclusion that these little defects are going to be...
There is a guy named Denny Guttierez over off of Santa Fe and Evans that has a small upholstery shop. I used him recently to sew in a panel on my Acura MDX seats. While I watched, he was able to remove the driver's seat from the car, uninstall the seat cover, repair the seat cover and...