Can’t slide the fork. Am I missing something? Differential knob is off, sensors unplugged. Unbolted that 10 mm inside the sensor and put a screwdriver in to try to pry the fork. It’s got a little give. But won’t slide past where it was initially bolted and slowly goes further towards the driver...
Gotcha, I’ll look into that.
And no, it drove really well before the locker issue. I make pretty consistent tight turns too. Roundabouts never seemed to be an issue. Never noticed any binding or chirping.
Also, was able to get the sensor plate off. I was just being a baby about the bolts...
Doesn’t seem to do anything, pressed it plenty of times while the transfer case was in different positions. My car does have trailer wiring, unplugged for now because it was causing issues with tail lights. Could be a hazard for the trailer wiring?
Okay so if I've got this right the VC acts like a part time CDL for when you're in high. But from what you've said adding a CDL switch and locking the transfer case in high is a preferable alternative.
Okay, so it's likely the different gear ratio which is making the wheels harder to turn at L when it shows the cdl locked, even though it's constantly locked. Learning a lot ty.
So looks like I've got a VC to take out from what I've skimmed. Will read further
Looks like a good tutorial...
Well I did previously. Went to test it and now heard nothing. Started the engine up. Heard some unpleasant sounds between low and high but no lights. I have had transmission shifter in neutral. Tried shifting transmission around seeing if that would free things up while in low on the transfer...
Ah so I suppose I'll try the S's out and report back? I will also say that I have an extra hazard button next to my rear heater switch. Looked it up a little while ago and found that it may be a cdl button. Was on the dash when I got it, messing with it doesn't seem to do anything.
Interesting. I'm rather positive the shifter is in the correct place, between the farthest forward position and before the center diff lock and abs light turn on. I'll describe the movement of the wheels in each position.
H - When turning the front right passenger wheel by hand, the other front...
No, as in both rear wheels turned simultaneously when turned both clockwise and counterclockwise. Also, when spinning rear wheels the front ones did as well despite the t-case being in neutral, assumed it was fine. The front ones spin independently and opposite of each other when they are...
Sorry, it's just a bad time to have my primary vehicle out of service. But that's what I get for getting an almost 30 year old truck and expecting nothing but sunshine and rainbows lol. Lesson learned. Anyway, was able to source some extra stands from a friend, got all four wheels off the...
Hey everyone, looked at a few threads on this issue and I'm gathering opinions on how I should proceed next.
The other night I had just finished up replacing transmission hoses, took it out for a spin and tested all the features of my triple locked 97 fzj80 checking to see if everything was...
Never got around to deleting this before you chimed in but yeah it was the bulb😅. Really simple fix just had to replace the bulb. Should I delete the thread? Kinda seems irrelevant to keep up.
Hey all, I'm having a real hard time diagnosing this brake light issue. Originally, my tail lights and brake lights were not giving anything. Through screwing with the trailer wiring adapter (small box in the passenger rear quarter panel) I have restored running tail lights to both sides and the...