Recent content by Couse44

Iv stumbled upon 10 links for 85 4Runner fsm. But for some reason none of them work any more. Would anyone be able to send me an up to date pdf link? Thanks

Haha! It’s been in my garage so long, it seems normal to keep sitting here.

I spent way too many hours trying to align the fender, bib, and aprons all together:bang: but I’ve finally decided it’s good enough lol those headlights are trucklites LED. The next thing will be to put the seats in! And I’d say damn near ready to fire her up! :D

New tail lights and marker lights in. Insulation for the front and rear. Battery tray was rusted pretty good, just a simple patch job done.

You guys are definitely right! Thanks very much!

So I’ve been chipping away at the interior and I came across this wire I have no idea where it goes to! It’s red with a black stripe, looks to be connected into the fuse block.... maybe. And it was just sitting under the steering wheel. Thanks for any help!

Painting odds and ends, all the random things I’ve missed. Had the glass guy come back make me a new windshield, and install all the glass back in. Getting all lines back into place, such as fuel lines, coolant, electrical. I also think I finally have distributor in place to were it needs to...

Gave the thermostat housing some metal cast paint, turned out pretty damn good!my father gave the valve cover a good polishing, and that turned out awesome also! Looks way better than painting it.things are going together slowly. Next up would be to get exhaust manifold all back together and...

Thanks! And yea things have been expensive through them, but also painless and simple service over the phone. And I am from Regina.

Haha I think I said that last year :rofl: but yes that would be a goal again lol

Gave the rusty bumper a fresh coat of paint, I will eventually build a bumper. Started pulling exhaust and intake manifold apart. I will probably just give exhaust a coat of paint also. Took the carb to my local backyard mechanic, I am too busy right now to figure out how carbs work lol...

Fresh coat on the 2F, maybe I should give the valve cover a fresh coat of grey?

Damn! Those look good. My call to 4wheelauto In Edmonton led me to believe 650.

It’s finally painted! Assembly has commenced! I’ll probably start putting engine, transmission, and transfer case all together within a week or so. Also bottom picture is our homemade gasket for going under hard top. I was quoted 650 bucks, so I said screw that.

Theres a good chance I will put factory stripes back on, but I’ll make a better decision once it’s all back together.