This is along the lines of what was wrong! Thank you for reminding me of this, I ended up disconnecting the sensor wire on the GM alternator after finding it made the voltage drop to 12.5v at 2000rpm. I removed it, leaving only the power wire to the Toyota harness and looped the tickler/voltage...
Okay, so I’ve done some digging into my 80 only to discover that my sensing (on/off or the wire that’s supposed to go to a dummy light) wire from my GM alternator isn’t going to anything. This has to be what’s causing my issues, right?
I’m still stumped as to which wire it should go to on the...
thank you for the input, I have a kind of different set up than most people with v8 swaps is definitely what I’ve gathered from this thread lol
I’ll double check my wiring and look into getting a fuse that goes to the battery (I really should have done that in the beginning looking back).
I...
Hey! It’s been a minute since I’ve posted on this thread but I really need some help here. I’ve been having alternator issues for a while and my 80s voltage goes far too high.
I don’t think my alternator (a Chevy 350 alternator) is hooked up correctly. I think the issue lies in the tickler...
I plan on making a build thread when I’m mostly done, just to keep it as organized as possible. And keeping the part numbers that I actually used vs. what I sent back because my brain works by trial and error lol
I’m keeping the A440F with plans to install a new torque converter and valve body...
Hello everyone! I am working on engine swapping my 80 that originally came with the 3FE and A440F combo to a second generation 350 small block Chevy with a cam and Vortec heads. I want to keep this swap simple, so I decided to keep my A440F transmission. I also want to go carbed in the beginning...
I have a 1992 FJ80 with the 3FE and A440F trans. When my family bought it (to later pass to me) we noticed the gear markings on the side of the knob do not go with the indicator on the dash. The dash reading is the correct one but has anyone else experienced this? Is there anything I can do to...
Hello all! I am working on beginning my engine swap for my 92 FJ80. The motor I am using is a 1996 5.7L Chevy that made around 350hp. I have everything figured out for the most part, not including the exhaust. For people who have done a Chevy V8 swap, what did you do with the exhaust and how...
I found an adapter for the stock transmission to the Vortec, im going to that route since my stock transmission is perfectly fine and doesn't slip or anything. Also so I don't have to worry about as much custom fabrication for transmission mounts and wiring.
Here's the link to the adapter if...
I am starting this thread to show progress on my 1997 Vortec swap with my 1992 Land Cruiser and keep track of parts. The engine options I have are a 5.7L Vortec and an old Camaro 350, the Camaro motor is a backup incase the Vortec doesn't start for some reason. My dad is the owner of these two...