Recent content by ClodBuster

  1. C

    Parting Out 2000 Lx470 Sacramento Ca.

    Any engine parts? Sorry didn't read through all 6 pages to see if it was sold. I need upper/lower oil pans, oil pickup, and oil baffle plate. Or whole engine. In Norcal.
  2. C

    Wanted 100 series upper/lower oil pan and pickup

    MT would be a long haul to NorCal where this project is located. But I would be interested in a complete engine in general. Truck as 240K mi on it, so preferably the transplanted engine is below that.
  3. C

    Wanted 100 series upper/lower oil pan and pickup

    I have a project 2001 LX470 that needs a motor. There are a few decent engines for sale locally but none from a LC or LX. Most likely I will be transplanting a 4runner/Tundra/Sequoia 4.7 unless a 100 series version falls out of the sky in the next week or so. That being the case, I'm trying...
  4. C

    Parting Out Bozeman, MT - 1998 100 Series, Parting out.

    It's on the interior of the door shell, and held to the exterior body panel by two 10mm head bolts. That middle housing contains the pivot shaft that the wiper arm attaches to. It probably makes the most sense to replace the whole rear wiper link assembly, if it's still usable. Otherwise if...
  5. C

    Parting Out Bozeman, MT - 1998 100 Series, Parting out.

    Was everything in the rear hatch completely destroyed? I'm looking for the cast aluminum block that's part of the rear wiper link:
  6. C

    Master Cylinder Rebuild - DIY

    Been lurking for a bit, and finally joined to try running down an answer to a parts sourcing question. Does anyone know if the plastic inlet fitting for the brake booster pump is available anywhere? It contains a small mesh filter and seems like it could be a generic part, but that might be...
Back
Top Bottom