Took it to a local shop yesterday that specializes in Toyota off road rigs. The guy said he's seen a lot of vehicles with ruined seals from the mud at Bridgeport, TX, that it seems to have a really fine grit that gets in there and ruins them. Glad to hear it's a least a semi-known thing and you...
I am definitely wondering if this was just coincidental, that maybe we noticed it because we pressure washed it afterwards? We have not greased the front driveshaft yoke recently, it's actually something that is on our to-do list.
When you replaced your seal how difficult was it? We've got a...
We definitely first noticed it right after going off road. It was quite muddy that day so we gave it a heavy wash afterwards. I'm wondering if maybe it had been existing and we just hadn't noticed it yet?
We did go through a quasi deep water/mud crossing that could have given some upward...
Took our 200 off roading and had a leak the next morning on the transfer case. It was dripping heavily and the transfer case was nearly empty by the time we got around to working on it. Thought the transfer case seal was leaking so tried refilling with fluid and the leak stop additive we've...
I appreciate all the feedback and help from everyone here. It’s a big relief to have this solved without having to invest a lot of time or $$ in parts. I wanted to make sure to gave an update in case anyone else comes across a similar scenario. So far I haven’t found another thread where a...
Thanks, that’s very helpful info about the black sleeve. It does come off so I’ll move forward with getting it back in place with some epoxy.
My husband suggested the epoxy route too, but I like to see if there’s a reasonable replacement cost before I start holding things together with glue. 😉...
Thought I’d give an update with what we’ve found…
Main culprit of our problem ended up being quite small: the knob for the 4WD switch is stripped. 🤦🏼♀️
Hubby suspects the Chevy techs did this since he had been able to get it to engage occasionally before they touched it. He was taking a...
Thank you! Yes, I’m calling BS on them pulling switches and testing, they don’t look like they’ve been touched at all. We haven’t had luck getting CDL or 4L to engage even when warm so looks like we will try servicing the actuators. From what we can tell PO never used 4L or CD so it’s likely...
I got the report from the Chevy tech who worked on it at the dealership. They reported that the switches on the dash were not reading the correct ohms and needed replacing. Thoughts on if these readings are correct, or could this just a symptom of something else within the CDL and 4L systems...
Thanks, and agree. It was not our preference but dealer was not acknowledging that there was a problem until the tech looked at it. In the end we figured we could get it worked out if they made the deal sweet enough. We've got our first trip planned to Red River in a few weeks so ready to get...
Good thought, I do remember reading another thread where they talked about letting it warm up and trying again. Taking it to go get inspected tomorrow so I'll give that a try. 👍
Hello everyone, new member and first post here. We recently purchased a 2008 LC as an off road rig/occasional street driver for my husband. We are longtime 4Runner owners and Toyota fans and are looking forward to a step up with the LC. Vehicle was a trade in with lots of aftermarket mods...