Recent content by Chuucher

To answer both things steering and air bumps. I need to get my FOA tank back from the place that is filling it with nitro to get my ride height dialed in. so I can address steering and air bump height. I am struggling a little with the issue of being so low. I really really need a RHD steeing...

IT CAN BE DONE!!! TRD 4:11 IN FJ80 HOUSING! THIS HELPS ME WITH MY TIGHT DRIVE SHAFT PROBLEM AS WELL.

IS this thing done yet

Just need brake lines installed, Locker and axle shafts. Rear is almost there.

GW Nugget The up travel is what it is. I am missing that one pic that would let you see what I did with the frame without cutting off the front of the frame and going full hydro steering there can be no more. Air bump is bottoming out 1/4" below the bottom of the frame. I have money to spend I...

Up travel with the air bums is 3 inches, down is 11. Its 4" lower than when I had 35's and a 4 inch leafs on it. Am planing to stay stock with the diff gears for now being that I have the granny gear. I could get the 80 high pinion to work but I just scored that e locker for...

here you go Bripars40

Lo rider 40 on 40's

Ok! I think that I may be doing something idiotic here but lets pretend its possible. Im trying to keep my center of gravity so low that I can no longer use the hi pinion axle in my fj80 housing due to it hitting the bell housing on the 350/nv4500. THE BIG QUESTION! Has anyone tried to use a...