I’m up for donations since it’s only $100... I’m going through all the trouble because all of the hard lines are corroded. The master cylinder is new and mounted and I’m working my way back.
No worries. I’ve found the 9mm to 10mm fitting for the master cylinder but am unsure of the wheel cylinders and lines to get there, hence my initial question. Master cylinder is brand new so I can’t rationally change it out.
I’m familiar with how a dual reservoir system works, I’ve been a mechanic for over 20 years. I would love to keep this vehicle but it’s coming to an end because of the deployment. I’ve no problem with safety or upgrades but with a brand new master cylinder along with an entire system through to...
The problem is all of the 9mm bits were frozen into the banjo fitting. From my understanding I can use later model wheel cylinders and just run new 10mm line.
How is it a safety issue if all of the fitting are new, the brakes are in good repair. Because I don’t want to run a dual system? I’m sure that’s saved about as many people as the TSA
Let me start this post with I’m sorry. I’m just trying to make sure I don’t screw this up because I’m ballin on a budget here. To do the conversion I need to replace all of the wheel cylinders with 69 and newer cylinders and then use the more common 10mm fittings and line? Can I still use my...