Yeah I wanted to clone a hard drive based on how much they cost but didn't want to go down the rabbit hole of figuring it out. The one I purchased is from this seller DETROIT SUPER STORE | eBay Stores - https://www.ebay.com/str/detroitsuperstore?_trksid=p4429486.m3561.l2563
To my knowledge...
I ended up buying a replacement hard drive for the nav unit from the seller "toyolexnavspec" on eBay. He currently has them listed for $1500 but accepted $500. Not a cheap solution but everything is back to normal and the seller was helpful with the process.
To remove the nav unit it's...
I've got a 2008 Lexus LX570 with Mark Levinson sound and after disconnecting the battery I'm getting this error message "A program cannot be read. Please consult to a dealer." Gah! There doesn't appear to be a DVD drive in the glove box, am I right to assume this is hard drive based? I've...
I'm wondering if someone can ellaborate on this process a little to get to 2.5" sensor lift in front? I mean specifically shortening the helm joint... A cut off wheel?
Attached is a photo of my setup currently, arrows pointing to the things I assume they're referencing, and then the photo...
When you mention rear spacer I assume you're referring to something like these? Rear Polyurethane Coil Spacer - 15mm Suited For Toyota 80 / 100 Series Land Cruiser/ Lexus LX450 / LX470 -...
I just did sensor lift based on this tut AHC Sensor Adjustment for Lift - https://forum.ih8mud.com/threads/ahc-sensor-adjustment-for-lift.60848/ and set the car to Neutral height for now based on everyone's input. I think it's about an inch lower, really prefer the look higher but I'm not...
Thanks again for the input. I'm wondering, what is the difference in the wear to the AHC system in having the ride height set to High with no sensor lift vs doing a sensor lift and setting the height to Neutral? Is there inherently higher AHC pressures with the High setting or is just the fact...
Thanks for the input. I have it locked in H, it drives fine in N too however the wheel alignment was recently done in H. I probably only drive 3-5k a year, the wife's Subaru is the main errand vehicle and MPG champion so I'm just wanting to make this vehicle fun and capable without throwing...
Howdy. I have 2002 LX470 that I drive in the "High" AHC setting as I have oversized tires and want the "free" lift. I'll be adding front diff drop soon to reduce wear on CV.
I recently got Techstream working and noticed my pressures were way high for the front, 10.9 in the High setting, I...
This navigation / radio trim was taken out of my 2002 Lexus LX 470 with Mark Levinson Navigation. It may be compatible with previous year models, buyer responsible for compatibility check. I believe the part # is 84010-60220
I took this out of my vehicle when doing a retro-fit of an...
I removed this from my LX 470 to do a retro-fit, it works as it should and is in great condition for the age. I believe this is part #88650-60570. $345 shipped.
The rca cable connectors (x4) front left, front right, rear left, rear right) on the Metra stereo wiring harness are connected to the pre-outs (front and rear) on my Alpine unit. There are no traditional speaker wires on the Metra adapter so I assumed this was the only way to do it. I'm going...